Recalling Preset RDS Stations
1 Press F/SETUP so that the “FUNC” indicator (only the underlined portion of the “FUNC” indicator for
2 Press 1/AF to activate the RDS mode.
3 Press F/SETUP to activate the normal mode. The “FUNC” indicator (only the underlined portion of the “FUNC” indicator for
4 Make sure that the “FUNC” indicator (only the underlined portion of the “FUNC” indicator for
If the preset station's signal is weak, the unit automatically searches and tunes to a stronger station in the AF (Alternative Frequencies) list.
5 If the preset station and the stations in the AF list cannot be received:
When the PI SEEK setting is on (refer to “PI SEEK Setting” on this page), the unit searches again for a station in the PI (Programme Identification) list.
If there are still no stations receivable in the area, the unit displays the frequency of the preset station and the preset no. disappears.
If the signal level of the Regional (Local) station being tuned becomes too weak to receive, press the same preset button to tune in a Regional station in other district.
•For presetting the RDS stations, refer to the Radio Operation section. The RDS stations can be preset in the FM1, FM2 and FM3 bands only.
Receiving RDS Regional (Local) Stations
1 Press and hold F/SETUP for at least 3 seconds to / activate the setting mode.
2 Press g or f to select the RDS REG (Regional) mode.
3 Press BAND/TEL. to turn on or off the RDS REG (Regional) mode.
In the RDS REG OFF mode, the unit automatically keeps receiving the related local RDS station.
4 Press F/SETUP to deactivate the setting mode.
PI SEEK Setting
1 Press and hold F/SETUP for at least 3 seconds.
2 Press g or f to select “PI SEEK”(CDA- 9811R:“PISK”).
3 Press BAND/TEL. to toggle the mode between “PI SEEK ON”
4 Press F/SETUP to set the selected mode.
Receiving Traffic Information
1 Press T.INFO so that the underlined portion of the “T.INFO” indicator lights up. (Only the upper lined portion of the “T.INFO” indicator for
2 Press g or f to select your desired traffic information station.
When a traffic information station is tuned in, the underlined portion of the “TP” indicator (only the upper lined portion of the “TP” indicator for
Traffic information is heard only when it is being broadcast. If traffic information is not being broadcast, the unit is set in the standby mode. When a traffic information broadcast begins, the unit automatically receives it and the display shows
When the traffic information broadcast is over, the unit will automatically set in the standby mode.
•If the traffic information broadcast signal falls below a certain level, the unit remains in the receiving mode for 1 minute. If the signal remains below a certain level for over 1 minute, the underlined portion of the “T.INFO” indicator blinks. (Only the upper lined portion of the “T.INFO” indicator for
•If you do not want to listen to the traffic information being received, lightly press T.INFO to skip that traffic information message. The T.INFO mode will remain in the ON position to receive the next traffic information message.
•If the volume level is changed while receiving traffic information, the changed volume level will be memorized. When traffic information is received next time, the volume level will be automatically adjusted to the level memorized.
•In the T.INFO mode, the SEEK tuning selects only the TP stations.