Remote Control
1
25
6 7 8
9
3!
4"
#
Controls on Remote Control
1Power Button
Press this button to turn the power on/off.
2Source Button
Press this button to select the audio source.
3
Press this button to switch between the Play and Pause modes for CD.
4TILT 98 Buttons
Press this button to adjust the angle of the movable display.
5Band/Programme Button Radio mode: BAND Button
Press this button and the band will change. CD/Changer mode: To switch the disc mode.
6Volume Adjustment Buttons To increase the volume level: Press the Lbutton
To decrease the volume level: Press the Kbutton
78 Button
Radio mode: Pressing this button will select, in ascending order, stations programmed into the radio's presets as shown below.
1 → 2 ... 6 → 1
CD Changer mode: DISC Select (UP) button
Press this button to select a disc in ascending order.
MP3/WMA mode: Press the Folder Select (UP) button to select the folder.
8g DN Button
Radio mode: SEEK (DN) Button
CD mode: Press this button to go back to the beginning of the current track.
9f UP Button
Radio mode: SEEK (UP) button
CD mode: Press this button to advance to the beginning of the next track.
!9 Button
Radio mode: Pressing this button will select, in descending order, stations programmed into the radio's presets as shown below.
6 → 5 ... 1 → 6
CD Changer mode: DISC Select (DN) button
Press this button to select a disc in descending order. MP3/WMA mode: Press the Folder Select (DN) button to select the folder.
"Mute Button
Press this button to lower the volume by 20 dB instantly. Press this button again to cancel.
#Audio Processor Button*1
Each press the button to switch the audio processor mode.
For details, refer to “Operating the Audio Processor” as shown below.
Press the button to call the external audio processor mode when the external audio processor is connected.*2
*1 This button is used for
*2 For the operation of external audio processor, refer to the Owner's Manual of the external audio processor you purchased.
Operating the Audio Processor (CDA-9815RB/CDA-9813R only)
1 Press A.PROC to select the mode.
Normal mode → EQ mode (Equalizer Presets) → Private mode (Recalling the Stored Equalizer Curve) → Time Correction mode (Recalling the Stored Time Correction) → Crossover mode (Recalling the Stored Crossover) → Normal mode
2 Press 8 or 9 to select the mode.
EQ mode
Select from FLAT, POPS, ROCK and NEWS.
Private mode/Time Correction mode/Crossover mode Select from MEMORY 1 through 6.