Installation | 3 Slide the | |
1 Remove the Detachable Front Panel (refer to | into the dashboard. When the unit is in place, | |
make sure the locking pins are fully seated in the | ||
page 4). Slide mounting sleeve from main unit. | down position. This can be done by pressing | |
(See Removal Procedure) Slide the mounting | firmly in on the unit while pushing the locking pin | |
sleeve into the dashboard. | down with a small screwdriver. This ensures that | |
Bracket | the unit is properly locked and will not | |
accidentally come out from the dashboard. Install | ||
| ||
Dashboard | the Detachable Front Panel. | |
| ||
Rubber Cap |
| |
(Included) |
| |
Hex Bolt |
| |
(Included) |
| |
Mounting Sleeve |
| |
(Included) |
|
2 When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the TDM-
NOTE:
For the screw *, provide a proper screw to the chassis installing location.
Metal Mounting Strap
Screw
∗Bolt Stud
Hex Nut (M5)
Lock pin
Removal
1Remove the detachable front panel.
2Use a small screwdriver (or similar tool) to push the locking pins to the "up" position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not
3Pull the unit out, keeping it unlocked as you do so.
<JAPANESE CAR>
Face Plate
Screws (M5 ⋅ 8) (Included)
Mounting Bracket