Radio Operation
SOURCE | BAND |
| F | |||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
DN g TUNE / A.ME | f UP | Preset buttons (1 through 6) |
Manual Tuning
1
2 Press the BAND button repeatedly until the desired radio band is displayed.
Each press changes the radio bands as follows:
→ F1 → F2 → MW → LW
3 Press the TUNE button repeatedly until "DX SEEK" and "SEEK" disappears from the display.
NOTE
The initial mode is
4 Press the DN g or f UP button to move downward or upward one step respectively until the desired station frequency is displayed.
NOTE
The ST indicator appears on the display when a Stereo FM station is tuned in. If the stereo FM signal becomes weak, the ST indicator disappears from the display and the unit automatically switches the mode from stereo to monaural to reduce the noise. When the signal becomes strong enough, the unit automatically switches back to the stereo mode.
Automatic Seek Tuning
1 Press the SOURCE button until radio frequency appears in the display.
2 Press the BAND button repeatedly until the desired radio band is displayed.
Each press changes the radio bands as follows:
→ F1 → F2 → MW → LW
3 Press the TUNE button to illuminate the DX and SEEK indicators in the display.
With the DX mode activated, both strong and weak stations will be tuned in the
Press again to return to the local mode. The DX indicator will turn off and the SEEK indicator will remain illuminated. Now, only strong stations will be tuned.
4 Press the DN g or f UP button to automatically seek a station downward or upward respectively.
When the unit finds a station, the unit stops at that station.
Press the same button again to seek the next station.
Manual Storing of Station Presets
1 Select the radio band and tune in a desired radio station you wish to store in the preset memory.
2 Make sure that the function indicator at the top side of the "F" button illuminates, then press and hold any one of the preset buttons (1 through
6)for at least 2 seconds until the station frequency on the display blinks.
3 Press the preset button into which you wish to store the station while the frequency display is blinking (within 5 seconds).
The display changes from blinking to steady lighting indicating that the station has been memorized. The display shows the band, preset No. with a triangle (9) and station frequency memorized.