OPERATION - Overhead Monitor
Headphone
Outputs (2)
SmartView Swivel
Mechanism
LCD Monitor
Panel
Monitor Open
Button
PUSH
Dome Light
IR Sensor/Logo
Headphone Outputs
Two output jacks
NOTE:
•Plugging a headphone into either jack will mute the Variable Audio Output.
SmartView Swivel Mechanism
The design of this mechanism provides the rear seat passengers a stable picture, viewable from many different angles. This system allows the LCD to tilt from 90 to 120 degrees in 10 degree steps. At the same time, the LCD will maintain its horizontal view while being rotated from left to right, up to 30 degrees, in 10 degree steps.
NOTE:
•The LCD will only close when rotation is at 0 degrees to prevent damage to the monitor.
•When rotating the monitor, use both hands on either side of the panel to ensure even pressure on the mechanism. This will prevent damage to the SmartSwivel mechanism.
•Make sure the panel is fully opened (90 degree position) before trying to rotate.
LCD Monitor Panel |
|
This is a 6.8 inch, TFT, Active Matrix, LCD. In addition, an Infrared Wireless Headphone |
|
transmitter is located on both sides of the LCD panel. When the monitor panel is closed, the |
|
power is automatically turned off. Once power is OFF, power can only be turned ON by using |
|
the Power button on the remote control (even after the panel is reopened). |
|
Monitor Open Button |
|
Press this button to release the Monitor Panel. The Panel will drop down slightly allowing you to |
|
fully open to its 90 degree or greater position. To close, firmly press the LCD Monitor Panel |
|
back up into the housing until a click is heard. |
|
IR Sensor/Logo |
|
There is an IR Sensor that receives the Remote Control commands at the front of the housing. At | 5 |
this same location is a |