Sound Setting
Rotary encoder/ /ENTER
AUDIO/SETUP |
Adjusting Subwoofer Level/Bass Level/
Middle Level/Treble Level/Balance (Between
Left and Right)/Fader (Between Front and
Rear)/Loudness/Defeat
1Press AUDIOSETUP repeatedly to choose the desired mode.
Each press changes the mode as follows:
SUBWOOFER*1 BASS LEVEL*2 MID LEVEL*2/*4 TRE LEVEL*2
BALANCE FADER LOUDNESS*2/*3/*4 DEFEAT VOLUME
SUBWOOFER
*1 When the subwoofer mode is set to OFF, its level cannot be adjusted.
*2 Adjustable only when DEFEAT is OFF.
*3 For details about loudness, refer to “Turning Loudness On/Off
*4 Only for CDE-HD137BT.
Subwoofer | +0 ~ +15 |
|
|
Bass level | −7 ~ +7*4 / −6 ~ +6*5 |
Middle level | −7 ~ +7*4 |
Treble level | −7 ~ +7*4 / −6 ~ +6*6 |
Balance | L15 ~ R15 |
|
|
Fader | R15 ~ F15 |
|
|
Loudness | ON/OFF |
|
|
Defeat | ON/OFF |
|
|
Volume | 0 ~ 35 |
|
|
*5 Only for
Setting value will change according to the level value set in BAND1 of
*6 Only for
Setting value will change according to the level value set in BAND5 of
Note
•If no operation is performed for 5 seconds, the unit automatically returns to normal mode.
2Turn the Rotary encoder until the desired sound is obtained in each mode.
By setting DEFEAT ON, previously adjusted settings of BASS, MID, TRE LEVEL and LOUDNESS will return to the factory defaults.
Audio Setup
You can flexibly customize the unit to suit your own preference and usage. From the AUDIO SETUP menu, Audio Setting can be modified.
Use steps 1 to 5 to select the category you wish to modify. For details on how to change each setting, see the following sections below.
1Press and hold AUDIOSETUP for at least 2 seconds to activate the SETUP mode.
2Turn the Rotary encoder to select AUDIO, and then press
ENTER.
AUDIO GENERAL DISPLAY TUNER SIRIUSXM*6 iPod
BLUETOOTH
3Turn the Rotary encoder to select the desired sound setting menu, and then press ENTER.
(e.g. Select SUBWOOFER)
FACTORY EQ*1/*2 LOUDNESS*1/*2 EQ MODE*2/*6 5BAND P.EQ*2/*3 7BAND G.EQ*2/*4 MX SETTING*2 3BAND EQ*1 VOL LV ADJ HPF*2 SUBWOOFER SUBW LPF*5 SUBW PHASE*5 SUBW SYS*5 POWER IC
*1 Only for
*2 Adjustment cannot be performed when DEFEAT is set to ON. *3 Only for
Displayed when EQ MODE is set to 5BAND P.EQ.
*4 Only for
Displayed when EQ MODE is set to 7BAND G.EQ.
*5 These functions are inoperable when Subwoofer is set to OFF. *6 Only for
4Turn the Rotary encoder to change the setting, and then press ENTER.
(e.g. Select SUBW ON or SUBW OFF)
5Press and hold AUDIOSETUP for at least 2 seconds to return to normal mode.
Notes
•Pressing returns to the previous Sound menu mode.
•Pressing and holding for at least 2 seconds will return to normal mode.
•If no operation is performed for 60 seconds, Sound menu mode is canceled.