Alpine CDE-9870R owner manual Installation, Removal

Page 26

Installation

Detachable

Front Panel

Caution

When you install this unit in your car, do not remove the detachable front panel.

If the detachable front panel is removed during installation, you might press too hard and warp the metal plate that holds it in place.

The main unit must be mounted within 35 degrees of the horizontal plane, back to front.

Less than 35°

1

Rubber Cap

Bracket

(Included)

 

Hex Bolt (Included)

Mounting Sleeve

Dashboard

(Included)

 

Pressure Plates*

This unit

*If the installed mounting sleeve is loose in the dashboard, the pressure plates may be bent slightly to remedy the problem.

Remove the mounting sleeve from the main unit (see “Removal” on page 25). Slide the mounting sleeve into the dashboard and fix it with the metal shackles.

2

Metal Mounting Strap

 

 

Screw

 

Bolt Stud

 

Hex Nut (M5)

 

This unit

When your vehicle has the Bracket, mount the long hex bolt onto the rear panel of the CDE-9870R and put the Rubber Cap on the hex bolt. If your vehicle does not have the Mounting Support, reinforce the head unit with the metal mounting strap (not supplied). Connect all the leads of the CDE-9870R according to details described in the CONNECTIONS section.

For the screw *, provide a proper screw to the chassis installing location.

3

Slide the CDE-9870R into the dashboard. When the

 

unit is in place, make sure the locking pins are fully

seated in the down position. This can be done by pressing firmly in on the unit while pushing the locking pin down with a small screwdriver. This ensures that the unit is properly locked and will not accidentally come out from the dashboard. Install the detachable front panel.

Lock Pin

Removal

1.Remove the detachable front panel.

2.Use a small screwdriver (or similar tool) to push the locking pins to the “up” position (see above drawing). As each pin is unlocked, gently pull out on the unit to make sure it does not re-lock before unlocking the second pin.

3.Pull the unit out, keeping it unlocked as you do so.

<JAPANESE CAR>

Front Frame

Screws (M5 × 8) (Included)

This unit

Mounting Bracket

25-EN

Image 26
Contents CDE-9870R Contents Operating Instructions Installation and Connections Operating Instructions Never Attempt the Following On handling Compact Discs CD/CD-R/CD-RW Adjusting Volume Accessory ListTurning Power On and Off Getting StartedTuning to Preset Stations Presetting Stations AutomaticallyPresetting Stations Manually RadioSetting RDS Reception Mode and Receiving RDS Stations Recalling Preset RDS StationsReceiving Traffic Information PI Seek SettingWhen traffic information stations cannot be received Receiving Traffic Information While Playing CD or RadioPlayback Repeat PlayFile/Folder Name Search Concerning MP3 X. Random PlaySearching from CD Text What is MP3? About MP3Press or until the desired sound is obtained in each mode Sound SettingPress AUDIO/RTN repeatedly to choose the desired mode Each press changes the mode as followsSetting the Bass Control Setting the Treble Control Displaying the Text Adjusting the High Pass FilterOther Functions Press or to select the desired HPF frequencySound Customizing Press or to change the settingAdjusting Source Signal Levels About the indication displayVisual Customizing External DeviceIPods usable with this unit Setting the AUX+ ModeIPod Optional Searching for a desired Song Direct Search FunctionRandom Play Shuffle M.I.X Basic InformationCase of Difficulty RadioIPod Indication for iPod ModeAudio Indication for CD PlayerSpecifications FM Tuner SectionInstallation and Connections Installation RemovalConnections Jaso Antenna Plug ISO Antenna PlugPower Antenna Lead Blue IPod Direct ConnectorSwitched Power Lead Ignition Red Battery Lead YellowPage Page Page Page Page Français Español Italiano NO. Label