Audiovox VOH701 manual General Installation Approach, General System Configurations

GENERAL INSTALLATION APPROACH:

1)Decide upon system configuration and options that will be installed (i.e.: what components, VCP, Tuner, RF Modulator/external amp, remote headphones, 2nd VCP, etc.).

2)Review all manuals to become familiar with electrical requirements and hook ups.

3)Decide upon mounting locations of all components and method of mounting.

4)Prep the vehicle by removing any interior trim necessary to gain access to vehicle's wiring as well as all areas where interconnecting wire harnesses will need to be located. If any access holes need to be cut into the vehicle (headliner, other trim components etc.), this should be done now as well. (Refer to Page 3).

5)Route the wiring harnesses throughout the vehicle as necessary. (Refer to the Wiring Diagrams on page 6 of this manual as well as the wiring instructions for the individual components and accessory options being installed). Be sure that all wiring is protected from sharp edges and is routed in such a manner that it will not be pinched when all components and interior trim are fully installed. Be sure to leave enough slack in the wiring at each component to allow working room.

6)Remove all A/V system components from their packaging and place them loosely in the vehicle at their respective locations.

7)Connect all components together (electrically) and verify proper operation of all system functions. Note: This is best done BEFORE, components have been permanently mounted.

8)After verifying proper operation of the system, proceed to mount of each component.

9)When all components are mounted, recheck function of entire system again to ensure that no wiring was pinched or connected improperly during final installation.

GENERAL SYSTEM CONFIGURATIONS:

The following is intended to give a rough guideline of system configurations that are possible with the VOH701 Drop Down Video Systems :

System 1: Video Monitor VOH701, VCP.

-All wiring necessary is included with this package.

-Headphones are connected into the headphone jacks on the monitor itself. System 2: Video Monitor (VOH701), VCP, 2nd VCP (or other A/V component)

-Same as system 1 but extra Source Component (PN 8010730) Harness must be purchased.

System 3: Video Monitor/TV (VOH701), VCP, 2nd VCP (or other A/V component) -Same as system 3, but TV antenna must be added (AN-300 or similar).

Notes :

-All systems have built-in game/camcorder inputs (the A/V input jacks on the video monitor itself). -There are a few audio output options that can be added as follows :

a)Remote headphone jacks can be added to a VOH701 system. Refer to the wiring diagram on page 6.

-The VOH701 video systems are only intended for an overhead, drop down installation. It is not intended for seat back or any other type of mounting. The hinging mechanism is designed for horizontal, drop down use only.

-2-