Audiovox ACC40 installation manual Procedure for Horizontal Installation

INSTALLATION

The unit can be installed horizontally, vertically or at a 45° angle. The position of the built-in anti-vibration springs (lef t and right side), must correspond to the mounting position chosen. If the springs are not set correctly for the type of installation chosen, the anti-vibration compensation will not be effective and vibration may cause the disc to skip.

HORIZONTAL INSTALLATION

Set the anti-vibration springs to position "H".

position "H"

45° H

V

VERTICAL INSTALLAITON

Set the anti-vibration springs to position "V".

position "V"

V 45°

H

45° ANGLE INSTALLATION

Set the anti-vibration springs to position "45°".

position "45°"

V 45° H

45°

PROCEDURE FOR HORIZONTAL INSTALLATION

1 Attach a mounting bracket to each side of the unit, using the 4 hex head bolts with washer base.

45° H

V

Bracket

NOTE: Make sure anti-vibration springs are set to position "H".

2 Determine the mounting location, and drill four mounting holes.

NOTE: If mounting surface is carpeted, use caution when drilling holes to prevent drill bit from catching on carpet. Cut holes in carpet before drilling into sub-surface.

Never mount the unit near the fuel tank.

3 Secure the unit in place, using four large self-tapping Phillips head screws.

Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion.

Bracket

Bracket	Hex head bolt
	with washer base

Drill holes 1/8" (4mm) in diameter.

Self-tapping Phillips head screw

(large)

Bracket

3