Procedure for 45 Angle Installation | Audiovox ACC40 instruction

PROCEDURE FOR 45° ANGLE INSTALLATION

Note

If the anti-vibration spring position has been changed and verified for 45° angle mounting (as shown on page 3), start with ste p 2.

1	Set the anti-vibration springs to position "45°".

position "45°"

	45°
V	H

45°

3 Determine the mounting location, and drill four mounting holes.

NOTE: If mounting surface is carpeted, use caution when drilling holes to prevent drill bit from catching on carpet. Cut holes in carpet before drilling into sub-surface.

Never mount the unit near the fuel tank.

2	Attach a mounting bracket to each side of the unit, using the
	4 hex head bolts with washer base.
	4 hex head bolts with washer base.

Bracket

Hex head bolt with washer base

4 Mount the unit in place, using four large self-tapping Phillips head screws.

Use RTV (silicone sealer) on screw threads or around the holes to prevent moisture intrusion.

Self-tapping Phillips head screw

(large)

Drill holes 1/8" (4mm) in diameter

Bracket