Vehicle Wiring, Mounting the FM Modulator

VEHICLE WIRING

IMPORTANT - Some import cars use a special dual antenna “Diversity" system. If your car has this type of antenna system, you will find the antenna cable will not fit the socket on the FM modulator. Use of the ACC-40 with “Diversity" systems is not recommended. You may also find some GM cars and others have an antenna plug that is too small to mate with the socket on the FM modulator. If this is found, call Audiovox’s Toll-Free Assistance for a special adaptor. This adaptor can also be purchased at most car stereo installation center.

+12V Accessory / Switched (ORANGE w/WHITE STRIPE) Connect this wire to a terminal which is energized when the ignition switch is turned to the "ON" or "ACCESSORY" position.

+12V Constant (GREEN w/WHITE STRIPE)

Connect this wire to a terminal which is always energized.

To FM radio antenna

From antenna		input
		FM radio
	Wired	FM modulator
Commander

Commander connection cord

Fuses

Ground (BLACK)

Attach this wire to the chassis of the car. Be sure that the surface is free of paint, and is not rusty. If a proper ground connection is not made, the CD changer may not operate correctly and stray noise may be picked

up by the unit.

CD changer

DIN cable

MOUNTING THE FM MODULATOR

Install the FM Modulator to the mounting surface with the small self-tapping screws (M3 x 12).

MOUNTING THE WIRED COMMANDER

1.Determine where the commander unit will be located.

2.Be sure that the mounting surface where the commander unit will be located is clean and dry.

3.Remove the protective paper from the back of the Velcro strip.

4.Apply the commander unit to the desired location.

After completing all connections, press the RESET button on the commander unit.

Self-tapping Phillips head screw (small)

Wired Commander

Velcro Strip

FM Modulator

Printed in Korea

128-5582A