Sharp CD-DH790NH Listening to a cassette tape, Tape playback, Various tape functions

Listening to a cassette tape

Note:

Tape recording function is not available in this unit.

Before playback:

●For playback, use normal or low-noise

tapes for the best sound. (Metal or CrO2 tapes are not recommended.)

●Do not use C-120 tapes or poor-quality

tapes, as they may cause malfunctions.

● Before loading a tape into the cassette compartment, tighten the slack with a pen or a pencil.

MINI COMPONENT SYSTEM

ON/STAND-BY	FUNCTION
	ON/STAND-BY
	VOL
	PUSH
	OPEN
	AUDIOIN
	PHONES

CD

USB

TAPE

■Tape playback

1Press the ON/STAND-BY button to turn the power on.

2Press the FUNCTION button on main unit repeatedly or TAPE button on remote control to select TAPE function.

3Open the cassette door

by pushing the area marked “ PUSH OPEN”.

PUSH

OPEN

4Load a cassette into the cassette compartment.

5 Press the / (TAPE ) button to start playback.

Auto power on function:

When you press any of the following buttons, the unit turns on.

●TAPE button (remote control): The unit turns on and the “TAPE” function is activated.

● / button on the main unit: The unit turns on and playback of the last function starts (iPod, CD, TUNER, USB, AUDIO IN, TAPE).

Auto power off function:

In the stop mode of tape operation, the main unit enters the stand-by mode after 15 minutes of inactivity.

■Various tape functions

Function	Main	Remote	Operation
	unit	control
Tape			Press in the stop
playback			mode.
Stop			Press in the
			playback, fast
			forward or fast
			rewind mode.
Fast	____		Press in the
forward/			playback or stop
Fast rewind			mode.

Caution:

● To remove the cassette, press the (TAPE ) button, and then open the compartment.

●If a power failure occurs during tape operation, the tape head will remain engaged with the tape and the cassette door will not open. In this case, wait until the power is restored.

16