Sony CDX-GT210, CDX-GT260S service manual CDX-GT21W/GT210/GT260/GT260S, Service Notes

Page 2

CDX-GT21W/GT210/GT260/GT260S

Power amplifier section

Outputs

Speaker outputs (sure seal connectors)

Speaker impedance

4 – 8 ohms

Maximum power output

 

 

50 W 4 (at 4 ohms)

General

 

Output

Power antenna (aerial) relay control terminal

Inputs

Antenna (aerial) input terminal

 

AUX input jack (stereo mini jack)

Tone controls

Low: ±10 dB at 100 Hz

 

High: ±10 dB at 10 kHz

Loudness

+9 dB at 100 Hz

 

+5 dB at 10 kHz

Power requirements

12 V DC car battery (negative ground)

Dimensions

Approx. 178 50 179 mm

 

(7 1/8 2 7 1/8 in.) (w/h/d)

Mounting dimensions

Approx. 182 53 162 mm

 

(7 1/4 2 1/8 6 1/2 in.) (w/h/d)

Mass

Approx. 1.2 kg (2 lb. 11 oz.)

Supplied accessories

Parts for installation and connections (1 set)

Design and specifications are subject to change without notice.

• Abbreviation

CND : Canadian model

CH : Chinese model

SERVICE NOTES

NOTES ON HANDLING THE OPTICAL PICK-UP BLOCK OR BASE UNIT

The laser diode in the optical pick-up block may suffer electrostatic breakdown because of the potential difference generated by the charged electrostatic load, etc. on clothing and the human body.

During repair, pay attention to electrostatic breakdown and also use the procedure in the printed matter which is included in the repair parts.

The flexible board is easily damaged and should be handled with care.

NOTES ON LASER DIODE EMISSION CHECK

The laser beam on this model is concentrated so as to be focused on the disc reflective surface by the objective lens in the optical pick- up block. Therefore, when checking the laser diode emission, observe from more than 30 cm away from the objective lens.

SAFETY-RELATED COMPONENT WARNING!!

COMPONENTS IDENTIFIED BY MARK 0 OR DOTTED LINE WITH MARK 0 ON THE SCHEMATIC DIAGRAMS AND IN

THE PARTS LIST ARE CRITICAL TO SAFE OPERATION. REPLACE THESE COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUBLISHED BY SONY.

Notes on Chip Component Replacement

Never reuse a disconnected chip component.

Notice that the minus side of a tantalum capacitor may be damaged by heat.

TEST DISCS

Please use the following test discs for the check on the CD section.

YDES-18 (Part No. 3-702-101-01)

PATD-012 (Part No. 4-225-203-01)

CAUTION

Use of controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure.

If the optical pick-up block is defective, please replace the whole optical pick-up block.

Never turn the semi-fixed resistor located at the side of optical pick- up block.

optical pick-up

semi-fixed resistor

ATTENTION AU COMPOSANT AYANT RAPPORT

À LA SÉCURITÉ!!

LES COMPOSANTS IDENTIFIÉS PAR UNE MARQUE 0 SUR LES

DIAGRAMMES SCHÉMATIQUES ET LA LISTE DES PIÈCES SONT CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE REMPLACER CES COMPOSANTS QUE PAR DES PIÈCES SONY DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU DANS LES SUPPLÉMENTS PUBLIÉS PAR SONY.

2

Image 2
Contents Specifications Ver .2Service Notes CDX-GT21W/GT210/GT260/GT260SCD Playback Unleaded SolderLead Free Mark Diagrams Table of Contents GeneralDisassembly Exploded ViewsConnections CDX-GT21W US SectionLocation of Control CDX-GT21W US Main unitConnection diagram Diagrama de conexión Location of Control CDX-GT21W CND/GT210 Connections CDX-GT21W CND/GT210Connection diagram Location of Control CDX-GT260/GT260S Connections CDX-GT260/GT260SConnection diagram Disassembly SUB Panel LCD Assy CD Mechanism BlockMain Board Servo BoardChassis T SUB Assy Roller ARM AssyChassis OP Assy Number of connected units display mode Reset count display modeReset count by watchdog timer display mode Operating hours display mode1 X X X X 051 Disc type and operating hoursMemo Section Diagrams Block Diagram Main SectionFor printed wiring boards Block Diagram Display SectionFor schematic diagrams Main BoardSemiconductor Location Printed Wiring Board Main SectionUses unleaded solder IC B/D IC B/D Refer to page 29 for IC Pin Descriptions Schematic Diagram Main /3Refer to page 20 for Waveforms Printed Wiring Board KEY Section OFFSchematic Diagram KEY Section IC Block Diagrams IC401 BD3444FS-E2 Main Board 1/3IC750 TDA8588BJ/N2/R1 Main Board 2/3 IC PIN Descriptions CyrilselPin No Pin Name Pin Description UnisiSection Exploded Views Main SectionFront Panel Section 5756CD Mechanism Section MG-101TA-188//Q 107Electrical Parts List KEYTransistor SWITCH, Tactile Mode KEY MainMain Main Servo 151 152 153 154 155 156 Memo Disassembly Chucking ARM SUB Assy 887-375-81Sled Motor Assy Optical PICK-UP Section Optical PICK-UPRevision History