Using the MH120 Desktop and Gang Chargers |
MH120 Gang Charger
The MH120 Gang Charger is designed to charge four Nickel Metal Hydride (NiMH) Battery Packs simultaneously. Full charging is accomplished in approximately one and a half hours. Chargers operate in a 50° to 85° F (10° to 30° C) environment.
Do not expose Gang Chargers to freezing temperatures or direct sunlight.
IMPORTANT
Figure
The Gang Charger is shipped with the appropriate power supply for the site's location. Use the following steps to connect the Gang Charger.
Step 1 Place the Gang Charger on a flat, horizontal surface.
Step 2 Plug the power supply into the Gang Charger and into an appropriate wall outlet.
Do not place anything in the MH120 Desktop Charger other than the Wireless
Telephone. You might damage the contacts. Bent contacts can keep the Battery
Pack from charging.
CAUTION
Using the Gang Charger
Use the following steps to remove the MH120 Wireless Telephone battery pack and recharge it in the Gang Charger.
Step 1 Remove the Battery Pack from the MH120 Wireless Telephone by depressing both battery release buttons. The Battery Pack releases.
Step 2 Insert the Battery Pack into one of the four charging bays so that the
Battery Pack contacts meet the charging bay contacts.
—The LED above the charging bay will turn on to indicate that charging is in progress.
—Complete charging occurs in one and a half to two hours. The Battery Pack is partially charged in five minutes.
When charging is complete, the LED turns off.
Mobile Handset 120 and Desktop Charger/Gang Charger User Guide - Revision 1