Sharp HT-SB602 Maintenance, Error indicators and warnings, Specifications,  Cleaning the cabinet

Maintenance

Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth.

Caution:

Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the cabinet fi nish.

Do not apply oil to the inside of each component. It may cause malfunctions.

Error indicators and warnings

When you fail to perform operations properly, the following messages are displayed on the sound bar.

Display Meaning

When there is no input signal. Play back the connected equipment.

Nonstandard signal. Cannot

	be recognized.
	 Signals other than DOLBY
	DIGITAL, DTS, Linear PCM
(Display blinks)	cannot be recognized.

Output power	MPO:
	160W (80W + 80W) (10% T.H.D.)
	RMS: Total 160 watts
	RMS:
	160 W (80 W + 80 W) (10% T.H.D.)
	RMS:
	120 W (60 W + 60 W) (1% T.H.D.)
Output	HDMI™ output: (audio/video support
terminal	up to 1080p) x 1
Input terminal	500 mV / 47 kohms
	Optical digital input (OPTICAL):
	Square type x 1
	HDMI input: (audio/video support up
	to 1080p) x 2
Type	2 Way speaker system
	5.7 cm woofer
	2.5 cm Soft Dome
Bluetooth	2.400GHz - 2.480GHz
Frequency
band
Compatible	A2DP (Advanced Audio Distribution
Bluetooth	Profi le), AVRCP (Audio/Video
Profile	Remote Control Profi le)
	Bluetooth 2.1 +EDR

Error indicator

(blinks red)

Poor connection of the digital audio input terminal.

Turn off the sound bar and check if the cable is connected properly.

 When the protection circuit is activated.

Maximum	160 W
input power
Rated input	80 W
power
Impedance	4 ohms

(*1): This power consumption value is obtained when the sound bar is in low power consumption mode.

(*): Should the same message appear even if the speaker is unplugged and plugged in, or is set to the standby mode and on again, contact your local dealer where you purchased the sound bar.

Specifications

As part of our policy of continuous improvement, SHARP reserves the right to make design and specifi cation changes for product improvement without prior notice. The performance specifi cation fi gures indicated are nominal values of production unit. There maybe some deviations from these values in individual unit.

Sound Bar

Power source	AC 220 - 240 V ~ 50/60 Hz
Power	Power on: 38 W
consumption	Power standby: 0.4 W (*1)
	Power standby: < 6 W (*2)
Dimension	Width: 1386 mm
	Height: 74 mm
	Depth: 68 mm
Weight	3.7 kg

(*2): This power consumption value is obtained in the STANDBY mode.

Subwoofer

Power source	AC 220 - 240 V ~ 50/60 Hz
Power	Power on: 33 W
consumption	Power standby: 0.4 W (*1)
	Power standby: 0.4 W (*2)
Output power	MPO: 150W (10% T.H.D.)
	RMS: 150 W (10% T.H.D.)
	RMS: 120 W (1% T.H.D.)
Type	Subwoofer system
	16 cm woofer
Maximum	300 W
input power
Rated input	150 W
power
Impedance	3 ohms
Dimensions	Width: 144 mm
	Height: 432 mm
	Depth: 306 mm
Weight	6.1 kg

E-19