Sharp HT-SB602 Sound bar preparation, To mount the sound bar on the wall,  Driving screws

Sound bar preparation

To mount the sound bar on the wall

Caution:

Be very careful to prevent the sound bar 3.7 kg from falling when mounting on the wall.

Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The sound bar may fall.) If unsure, consult a qualified service technician.

Mounting screws are not supplied. Use appropriate ones.

Check all wall mount angle screws for looseness.

Select a good location. If not, accidents may occur or the sound bar may get damaged.

SHARP is not responsible for accidents resulting from improper installation.

Driving screws

SHARP designed the sound bar so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.

3.2 mm

5 mm

9 mm

Min. 22 mm

Fixing wall mount angle (Horizontal position)

1Fix the pattern paper to the wall in horizontal position as below.

926 mm	44 mm
Wall surface 44 mm	29 mm
29 mm	Pattern paper

2Make a hole on the wall following the screw point marks on the pattern paper by using a

drill.

32 mm

8-9 mm

Wall surface

3Fix a wall mount plug (not supplied) into the hole using a hammer, until it is flush with the

wall surface.

32 mm

8-9 mm

Wall surface

4Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 8 pieces)

Wall mount angle
Wall mount
angle	Wall	Wall
(screws x 4)	surface	mount
Wall surface		angle
(screws x 4)
Wall surface

Note:

Make sure all screws are fully tightened. (screws are not supplied)

Installing the sound bar

1Align the wall mount slot at the sound bar to the wall mount angle.

2Slot the sound bar into the wall mount angle.

3Fix them securely.

Wall surface

E-5