SECTION 4
PROGRAMMING INSTRUCTIONS
1 Hardware Setup
The software programming setup requires a PC (386 type or higher) and the bootadaptor kit. The boot adaptor kit consists of bootadaptor, cables and power supply.
•Connect RS232 cable from bootadaptor to
•Connect power supply (9V) to bootadaptor
•Connect bootadaptor to CMDX2000
2 Software setup
The software is distributed automatically after registration of the bootadaptor. Install the software into a dedicated directory on the PC. It is ADVISABLE to perform the software programming ONLY starting from DOS, not under Windows. If starting under windows, there is a slight chance that the windows program, still running on the background, causes interruptions which might prove to be fatal.
Following files are available :
•swupinst.exe : this program enables you to choose language, to check
•swup.ini this file contains language setting and
•langgrpX.xbi : each langgrpX.xbi file contains the full software package for a certain language group, when starting the programming the correct choice of language group has to be made by operator
•swup.exe : start program for software programming, following options are possible :
–swup.exe /i : information on the software version is shown
–swup.exe /h : a small helpfile is shown
–swup.exe langgrpX.xbi : starts the software programming sequence for a language group.
3 Programming instructions :
•Make sure a battery is in the CMDX2000.
•Make sure the bootadaptor is powered.
•Connect CMDX2000 to bootadaptor and check proper connection from bootadaptor to PC.
•Start PC under DOS, or exit windows.
•Start software programming sequence with instruction: swup.exe langgrpX.xbi (X = number of language group, depending on available language group files).
•The software update will now be performed automatically, no further intervention is needed.