Sharp HT-CN400DVH Maintenance, Specifications, Cleaning the cabinet, Care of DVD/CD discs

Page 58

HT-CN400DVH HT-CN500DVH

ENGLISH

References

Maintenance / Specifications -

Maintenance

!Cleaning the cabinet

Periodically wipe the cabinet with a soft cloth and a diluted soap solution, then with a dry cloth.

"Do not use chemicals for cleaning (petrol, paint thinner, etc.). It may damage the cabinet finish.

"Do not apply oil to the inside of the unit. It may cause malfunctions.

!Care of DVD/CD discs

DVD/CD discs are fairly resistant to damage, however mistracking can occur due to an accumulation of dirt on the disc surface. Follow the guidelines below for maximum enjoyment from your DVD/CD collection and player.

"Do not write on either side of the disc, particularly the non-label side from which signals are read. Do not mark this surface.

"Keep your discs away from direct sunlight, heat, and excessive moisture.

"Always hold the DVD/CDs by the edges. Fingerprints, dirt, or water on the DVD/ CDs can cause noise or mistracking. If a DVD/CD is dirty or does not play properly, clean it with a soft, dry cloth, wiping straight out from the centre, along the radius.

NO

 

 

YES

 

 

Correct

 

 

 

 

 

 

 

 

 

 

 

Specifications

As part of our policy of continuous improvement, SHARP reserves the right to make design and specification changes for product improvement without prior notice. The performance specification figures indicated are nominal values of production units. There may be some deviations from these values in individual units.

" General

Power source

AC 230 V, 50 Hz

 

 

 

 

Power consumption

HT-CN400DVH:

 

 

Power on: 88 W

 

 

Power stand-by: 0.6 W

 

 

 

 

 

HT-CN500DVH:

 

 

Power on: 105 W

 

 

Power stand-by: 0.6 W

 

 

 

 

Dimensions

Width: 430 mm (16-7/8")

 

 

Height: 53 mm (2-1/8")

 

 

Depth: 337 mm (13-1/4")

 

 

 

 

Weight

4.2 kg (9.3 lbs.)

 

 

 

 

Audio input terminals

Analogue input (IN 1): RCA type

1 pair (L/R)

 

Analogue input (IN 2): RCA type

1 pair (L/R)

 

 

 

Audio output termi-

Analogue output (OUT): RCA type

1 pair (L/R)

nals

Headphones: 16 - 50 ohms (recommended: 32 ohms)

 

 

 

 

Video output termi-

SCART output: SCART terminal

1

nals

S-video output: S-terminal 1

 

 

 

 

Video output: RCA type 1

 

 

 

 

"Amplifier (HT-CN400DVH)

7

-

Output power

Front speakers:

RMS: 60 W (30 W + 30 W) (10 % T.H.D., 1 kHz)

Centre speaker:

RMS: 30 W (10 % T.H.D., 1 kHz)

Surround speakers:

RMS: 60 W (30 W + 30 W) (10 % T.H.D., 1 kHz)

Subwoofer:

RMS: 50 W (10 % T.H.D., 100 Hz)

SHARP 92LCN400E0270

E-51

03/7/2

HTCN400_500DVH_E.fm

92LCN400E0270

Page 57 Page 59
Image 58
Page 57 Page 59
Contents Modell Modello Modèle Model Modelo Modelo Avertissement Dichiarazione di conformitàWarnung AdvertenciaWaarschuwing AvvertenzaAdvertê ncia Cuidado VorsichtAttenzione VaroitusObservera VorsichtPrecaució N Attenzione0110 0306 0304 General Information IntroductionTypes of playable discs Copyright InformationContents Accessories AccessoriesOptional accessories FM aerial AM loop aerialGeneral Information Precautions PrecautionsVolume control GeneralTitle, chapter and track Description of discsDiscs that cannot be played Icons used on DVD discsHellenic Republic Names of nations and areas Common names Names of nations and areasInformation Controls and indicatorsIndicators Main unit front panelControls Main unit rear panelBottom of the unit General 14 15 16 17Subwoofer Front/centre/surround speakersSpeaker functions Connections Speaker connectionSpeaker connection Aerial connection Connecting speaker wiresSystem Connections Speaker connection / Aerial connection Connecting to a TV with a video input socket Connecting to a TV with an S-video input socketConnecting to a TV with a Scart socket Setting Video OutputAudio connection to other equipment Connecting the AC power leadAudio connection to TV or VCR Connections to TV, VCR, etcPlacing the speaker system System installationPreparation for Use System installation Magnetically shielded speakersTest of the remote control Battery installationTurning the power on To turn the power onChanging the setup menu For Use menuSpeaker Setup Preparation for Use Changing the setup menuGeneral Setup Audio SetupExit Setup PreferencesVideo output setting TV display settingTV type setting For Use the setup menuParental setting Language settingPassword setting Treble and Bass HeadphonesGeneral control MutingPress the OPEN/CLOSE button to close the disc tray DVD playbackDVD Operation DVD playback If playback does not start in , press the Play / buttonTo resume playback after stopping Resume play DVD mode operation indicatorsPlaybackDVD Fast forward/Fast reverse search Basic operationTo locate the beginning of a chapter track Skip DVD Operation Basic operationTo play by specifying time time search To start playback from the desired point Direct playWithin 10 seconds, press the Enter button TV screen Unit display Title 01/02 /002Slow-motion play Useful operationStill picture/Frame advance DVD Operation Useful operationTo zoom images zoom To change the angleWhilst a disc is playing, press the Zoom Button TV screen Unit display To play repeatedly repeat playWhilst a disc is playing, press the Repeat button Chapter Repeat onTo select a title from the top menu Disc Disc menuDVD Operation Various settings Various settingsTo change the audio language audio out Put To change the audio channel To change the TV typeTo change the display on TV screen DVD VariousSuper Video CD and Super Video CD playbackVideo CD Operation VideoVideo CD Operation VideoCD playback To start playback from the desired pointTo play without activating the playback Control function Super and SuperRWOperation CD operationTo play in the desired order programmed Play Whilst stopped, press the Prog buttonCD-R MP3 MP3 and Jpeg disc operationPlayback on the MP3 menu screen Load a disc containing MP3 and Jpeg filesJpeg OperationRWdisc operation MP3Rotating a picture CD-RW OperationZoom function Jpeg disc operationListening to the radio Manual or Auto tuningRadio Operation Listening to the radio Memorising a station To recall a memorised stationRadio Operation Using the Radio Data System RDS Using the Radio Data System RDSInformation provided by RDS Affairs AlarmNews InfoDTS or Dolby Digital Surround Advanced FeaturesEnjoying various sounds Enjoying various soundsDolby Pro Logic surround Unit display Dolby Pro Logic SurroundDolby Pro Logic surround Speaker delay time setting Adjusting speaker delay time/speaker levelAdvanced Adjusting speaker delay time/speaker level Speaker level settingTest tone Sleep operation Setting the sleep timerSleep operation Play back the desired sound source Press the Sleep buttonError indicators and warnings References Error indicators and warningsSymptom Possible cause Reference Troubleshooting chartTroubleshooting chart ReferencesIf trouble occurs Remote controlTuner Before transporting the unitCleaning the cabinet MaintenanceSpecifications Maintenance / SpecificationsSpecifications Sharp Corporation HT-CN400DVH/HT-CN500DVH Home Cinema with DVD
Top Page Image Contents