M3588
4.1 Disassembly Introduction
The M3588 is held together by 5 screws as other Modulus products,1 of these screws is placed beneath the IMEI label, and 2 of these are placed below the Aux RF connector rubber cover. Care should be taken whilst removing the display flex cable as this can be torn or broken without too much stress being applied.
Ensure that a properly grounded high impedance conductive wrist strap is used whilst performing any tasks during the disassembly and assembly of the unit
Avoid stressing the plastics in any way to avoid damage to either the plastics or internal components.
!! CAUTION !!
Many of the intergrated devices used in this equipment are vulnerable to damage from
4.2Recommended Tools
The following tools are recommended for use during the assembly / disassembly of the M3588.
∙
Ground Cord
∙Plastic Bladed Tool SLN7223A
∙T7 Torx Driver
4.3Disassembly Procedure
The following set of diagrams will demonstrate the correct sequence and action required to disassemble the M3588
The use of the exploded diagram on page 18 may be of some assistance for part recognition.
4.4Assembly Procedure
Once the unit is disassembled and the repair is carried out, the unit must then be reassembled, this is carried out in the exact reverse order as the disassembly.
14 of 45 | European Customer Services |