System preparation (continued)
Caution:
●Be very careful to prevent the sound bar [1.46 lbs (0.66 kg)] from falling when mounting on the wall.
●Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The sound bar may fall.) If unsure, consult a qualified service technician.
●Mounting screws are not supplied. Use appropriate ones.
●Check all wall mount angle screws for looseness.
●Select a good location. If not, accidents may occur or the sound bar may get damaged.
●SHARP is not responsible for accidents resulting from improper installation.
●Do not let children dangle on the sound bar once it is attached on the wall as it can cause damage and injury.
Driving screws
SHARP designed the sound bar so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.
1/8" (3.2 mm)
3/16" |
|
(5 mm) | 3/8" (9 mm) |
| 7/8" (Min. 22 mm) |
Fixing wall mount angle
1 Fix the pattern paper to the wall in horizontal position as below.
4Screw the wall mount angle to the wall as shown in the illustration. (Total screw is 4 pieces)
Wall mount angle
Wall mount |
| |
angle | Wall | |
Wall | ||
mount | ||
(screws x 2) surface | ||
| angle |
Wall surface (screws x 2)
Wall surface
Note:
Make sure all screws are fully tightened. (screws are not supplied)
Installing the sound bar
1Align the wall mount slot at the sound bar to the wall mount angle.
2Slot the sound bar into the wall mount angle.
3Fix them securely.
Wall surface
523 mm
Wall surface 30 mm
30 mm
Pattern paper
2Make a hole on the wall following the screw point marks on the pattern paper by using a drill.
3/8"
Wall surface
3Fix a wall mount plug (not supplied) into the hole using a hammer, until it is flush with the wall surface.
3/8" 
Wall surface
Falling prevention
Safety wires (not supplied) are useful to prevent the sound bar from falling off the table.
L
R L
R
Loop the safety wires (not supplied) into each hole as shown and tie the safety wires to the LCD TV stand.