Sharp HTSB250 operation manual System preparation, Driving screws

System preparation

Make sure to unplug the AC power cord before installing the unit or changing the position.

Select from three installation methods according to the preferred position.

Using spikes

Nuts (secured on spikes) must be used when installing spikes.

The unit can be levelled by adjusting the spikes and nuts.

Option 2 Option 1

Note:

Option 1 or option 2 foot cushion positions based on LCD TV stand.

To mount the unit on the wall

Caution:

●Be very careful to prevent the unit [4.19 lbs. (1.90 kg)] from falling when mounting on the wall.

●Before mounting, check the wall strength. (Do not put on the veneer plaster or whitewashed wall. The unit may fall.) If unsure, consult a qualified service technician.

●Mounting screws are not supplied. Use appropriate ones.

●Check all wall mount angle screws for looseness.

●Select a good location. If not, accidents may occur or the unit may get damaged.

●SHARP is not responsible for accidents resulting from improper installation.

Tighten all spikes as shown

Notes:

●Option 1 or option 2 indicates spike positions based on LCD TV stand.

●When attaching the spikes, place the unit on a cushion or soft cloth to avoid damage.

Caution:

When using these spikes on glossy or slippery table such as on glass top, stick foot cushions at the bottom of the spikes to avoid slippage.

Using foot cushions

■Driving screws

SHARP designed the units so you may hang them on the wall. Use proper screws (not supplied). See below for size and type.

	1/8” (3.2 mm)
3/16”
(5 mm)	3/8” (9 mm)
	Min. 7/8” (22 mm)

■Wall mount angle fixed to the wall (Horizontal position)

Fix the pattern paper to the wall in horizontal position as below.

Option 2	Option 1		44 mm
		509 mm
	Wall surface		29 mm
		44 mm
Attach foot cushions as shown	29 mm		Pattern paper
	E-