U-Line manual Installation of the BI-95, Grille Installation, Installation Troubleshooting

BI-95 Ice Maker

9 Install the Unit

Installation of the BI-95

1.Open the water supply valve in the main water source.

2.Plug in the power cord.

3.Gently push the unit into position. Be careful not to kink the water supply line or entangle the electrical cord.

4.Re-check the leveling, from front to back and side to side. Make any necessary adjustments. The unit’s top surface should be approximately 1/8" below the countertop.

Grille Installation

1.Locate and remove the grille screw from the cabinet, using a standard blade screwdriver (or a 1/4" nutdriver). See Figure 21.

Grille Screw

Figure 21

2.Identify the grille screw hole on the grille itself. It is located toward the top of the middle recessed section of the grille.

3.Place the two hook-hinges (located on the rear bottom side of the grille) onto the front lip of the unit base. Swing the grille up into position, aligning the grille screw hole on the grille to the grille screw hole on the cabinet. See Figure 22.

Grille

Hook-Hinge

Unit Base

Front Lip

Figure 22

4. Insert the screw. Do not overtighten.

Installation Troubleshooting

Q: Problem

Water is leaking under the unit.

A: Solution

A water leak under the unit is most likely caused by a bad connection in the water supply line. Make sure the water line’s brass fitting is screwed tight to its valve and threaded correctly. Make sure that plumbers tape was NOT used; if it was remove all traces before reinstalling.

www.U-LineService.com 10 02/2005