Connect the boom brace, Install the transformer

Step 8: Connect the boom brace

Lay the boom brace on top of the antenna. Make sure the mast clamps (the brass-colored sections) on the boom brace and antenna are facing the same direction.

English

Fig. 8

Locate the screw hole in the reﬂ ector boom and attach the brace with one of the provided #10 screws and nuts. (See ﬁ gure 8.)

Fig. 9

Nut

Screw

Swing the boom brace down towards the rear. Form a “V” with the metal straps. Use one of the provided #10 screws and nuts to attach the “V” to each side of boom. (See

ﬁ gure 9.)

Step 9: Install the transformer

Find the downlead connection on the bottom of the front section of the antenna, just beyond the reﬂ ector booms.

Place two washers on each of the studs. Place a #10 nut on top of each stud, but don’t tighten them yet.

Place the transformer ends between the two washers and tighten the nuts securely. (See ﬁ gure 10.) Attach the coax downlead to the transformer.

Fig. 10
	Downlead
Transformer	connections