Sharp HTSB600 Listening to the radio, Tuning, Memorizing a station, To recall a memorized station

Listening to the radio

HDMI

ARC

TV 1 2 3

DIGITAL LINE

1 2 1 2

CLOCK TIMER

DIMMER TUNING TUNER(BAND)

EQUALIZER X-BASS BASS/TREBLE MUTE

TUNING

Note:

This product can receive FM stereo/FM monaural/AM broadcasts.

Tuning

1Press the ON/STAND-BY button to turn the power on.

2Press the INPUT button on the main unit or TUNER(BAND) button on the remote control repeatedly to select the desired frequency band (FM Stereo/FM Mono/AM).

3Press the (TUNING or ) button to tune in to the desired station.

Manual tuning:

Press the (TUNING or ) button as many times as required to tune in to the desired station.

Auto tuning:

When the (TUNING or ) button is pressed for more than 0.5 seconds, scanning will start automatically and the tuner will stop at the first receivable broadcast station.

Notes:

●When radio interference occurs, auto scan tuning may stop automatically at that point.

●Auto scan tuning will skip weak signal stations.

●To stop the auto tuning, press the TUNING button again.

To receive an FM stereo transmission:

●“ ” will appear when an FM broadcast is in stereo.

●If the FM reception is weak, press the TUNER(BAND) button to extinguish the “ST” indicator. The reception changes to monaural, and the sound becomes clearer.

FM stereo mode indicator

FMST

FM stereo receiving indicator

Listening to the radio (continued)

Memorizing a station

You can store 40 FM stations in memory and recall them at the push of a button. (Preset tuning)

1Perform steps 1 - 3 in “Tuning” on page 18.

2Press the ENTER button to enter the preset tuning saving mode.

3Within 5 seconds, press the PRESET ( or ) buttons to select the preset channel number. Store the stations in memory, in order, starting with preset channel 1.

4Within 5 seconds, press the ENTER button to store that station in memory.

If the preset number indicators disappear before the station is memorized, repeat the operation from step 2.

5Repeat steps 1 - 4 to set other stations, or to change a preset station.

When a new station is stored in memory, the station previously memorized will be erased.

Note:

The backup function protects the memorized stations for a few hours should there be a power failure or the AC power cord become disconnected.

To recall a memorized station

Press the PRESET ( or ) button for less than 0.5 seconds to select the desired station.

To erase entire preset memory

1.Hold the TUNER(BAND) button on the remote control for 4 seconds or more.

2.While “CLEAR” is flashing, press the ENTER button.

E-18