Chapter 2 Basic Functions
Turning the Phone On and Off
Turning the Phone On
1)Install a charged battery pack or connect the phone to an external power source such as the cigarette lighter adaptor or car kit.
2)Hold down the Key 
for 2 seconds until the LCD screen flashes.
NOTE As any other communication device, avoid any unnecessary contact with the antenna while your phone is turned on.
Turning the Phone Off
1)Press and hold 
until display screen turns off, then release the key.
Signal Strength
The quality of a call depends on the strength of the sig- nal supplied by the operator. The phone shows its signal strength through bars, located at the left top of the screen. If there are more bars (a maximum of six), the phone holds more signal strength. If the signal strength is not satisfactory, try to change the position of the phone. If you are in a building, try to be near to a win- dow, where the reception of the signal may be better.
In some places such as : tunnels, elevators, basements and garages, there may be limitation of the signal sup- plied by the operator.
Power Save Mode
When the phone is in an area without service for about 5 minutes, it stops searching for service and enters into the Power Save Mode. When your phone activates this feature, Power Save is displayed on your screen. The phone automatically checks for service periodically or you can check manually by pressing any key.
Making a Call
Every time you make a call, follow these steps:
1)Make sure that the phone is turned on. If not, hold
down 
for 2 seconds.
2)Type the phone number and then press 
.
If the phone is locked, type the lock code. The lock code is '0000' by default.
3)To end the call press 
.
Correcting Dial Errors
If you typed a wrong number, press the Key 
once to delete the lastly typed digit, or Hold down the Key 
for 2 seconds to delete all the typed digits at the same time.
Chapter 2
Basic Functions
20 | 21 |