RCA RS2653 Getting Started General Controls, Connecting the Speakers, Main Unit Installation

RS2653_55_EN(TCEC) 1/13/06 1:27 PM Page 6

Getting Started

General Controls

EN Unpacking the system:

You should have the following:

•one main unit (with 2 main speakers);

•one remote control;

•one AM loop antenna;

•one user’s guide;

•one safety leaflet.

•Owner registration Card

Back View

	1
3	+
	2

Connecting the Speakers

Match the red wire (on the left speaker) to red terminal for the left speaker (L) on the back of the unit and the black wire (on the left speaker ) to the black terminal for left speaker (L). Follow the same procedure to con- nect the right (R) speaker.

Speaker Wire Connection

Push Speaker terminal tab	Release tab to lock wire in
down to insert wire.	the terminal.

NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.

Main Unit EN

Installation

To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:

ON/STANDBY — Turns power on or off (STANDBY mode).

Tip:

Press ON/STANDBY to turn the sys- tem on in the previously used mode. Press CD, TAPE, TUNER or AUX

DIGITAL TUNING (SKIP FORWARD) — Tunes up radio frequency, selects preset radio channels, goes to the next CD track or setting option, fast searches for- ward through the CD.

PLAY / PAUSE — Plays or pauses CD. TUNE•PRESET — Stops CD track, Sets tune or pre- set mode.

1.FM Pigtail Antenna

2.AM Loop Antenna Connector

3.Main Speaker Jacks

Using the FM and AM Antennas

Before you use your audio system, you’ll want to make sure both the FM and AM antennas are positioned properly. Uncoil the FM antenna at the back of the unit, making sure it is fully extended (you may even want to tape it to the wall behind the unit if possible. The higher the better.) You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.

Front View	4 inches
4 inches	4 inches

Side View	4 inches
2
inches

(Remote Only) to select the corresponding mode. Look at the display icons to identify the current mode.

GAME •mp3• L / R / AUX IN - Jack for auxiliary input connection.

PHONES — Jack for connecting headphones OPEN/CLOSE — Opens or closes the disc tray. DISC SKIP — Skips to the next CD in the tray. VOLUME CONTROL — Increases/ decreases volume. SOURCE — Selects among CD player, tuner, tape player and AUX sources.

DIMMER•DEMO —Turns the feature demonstration on or off; adjusts display brightness;

TIMER — Enters timer setting mode and turns the timer on/off.

CLOCK — Shows time and enters clock setting mode. BASS BOOST — Turns BASS BOOST on or off.

DIGITAL TUNING (SKIP BACKWARD) — Tunes down radio frequency, selects preset radio channels, goes to the previous CD track or setting option, fast searches backward through the CD.

PROG•SET - Enters program mode for CD and Tuner; applies new settings for Clock and Timer modes.

BAND/AUTO PROG. — Changes between FM and AM tuner bands, enters auto preset program in FM mode.

CD INFO — Selects among disc display information. REPEAT — Selects among repeat modes.

Tape Player

PLAY

REWIND

FAST-FORWARD

STOP/EJECT

2 3