RS2056 EN 6/9/06 9:58 AM Page 10
Getting Started
Getting Started
EN Content of Box | Connections of Antennas and | ||
• | one main unit (with 2 main speakers); | Speakers |
|
• | one remote control; |
|
|
• | one AM loop antennas; |
|
|
• | one mp3 Player; |
|
|
• | one pair of earphones |
|
|
• | one user manual; |
|
|
• | one safety leaflet; |
|
|
• | Owner registration Card. |
|
|
|
| 1 | 3 |
Using the FM and AM Antennas
Before you use your audio system, you’ll want to make sure both the FM and AM antennas are positioned properly. Uncoil the FM antenna at the back of the unit, making sure it is fully extended (you may even want to tape it to the wall behind the unit if possible. The higher the better.) You’ll also need to connect the AM antenna loop to the back of the unit if you listen to AM stations. Rotate the AM loop antenna for better reception.
Installation | EN |
To ensure sufficient ventilation, keep the spacings shown below free from other surfaces:
| 4” |
|
4” | Front View | 4” |
!
Warning:
Use of this product is for your personal use only. Unauthorized recording or duplication of copyrighted material may infringe upon the rights of third parties and may be contrary to copyright laws.
Note:
2 | 4 |
1.AM Loop antenna Jacks.
2.AUX IN.
3.FM Pigtail Antenna.
4.Main Speaker Jacks.
Connecting the Speakers
Each speaker has a black (negative) and a red (positive) jack. When connecting the speakers, match the red wires to the red jacks and the black wires to the black jacks.
Speaker Wire Connection
4” |
2“ |
Side View
Make sure the tracks are encoded in mp3 or Windows Media formats and supported bitrates. Bitrates supported by the player:
mp3 – 32 to 320kbps wma – 48 to 160kbps
Push Speaker terminal tab | Release tab to lock wire in |
down to insert wire. | the terminal. |
NOTE: Make sure the insulation is completely removed from the ends of the speaker wires at all connection points.
3 |
|
|
| 4 |
|
|
|
|
|