Connecting to Subwoofer Out or Pre Out Terminals

Connecting to Subwoofer Out or Pre Out Terminals

Use this connection if your amplifier/ receiver has jacks labeled SUBWOOFER OUT or PRE OUT. Do not use the PRE OUT jacks if they are already connected by cables or jumpers to your amplifier.

Right	Amplifier/Receiver	Left
Speaker Sub Out/Pre Out Terminal Speaker

Right Speaker	Amplifier/Receiver	Left Speaker
Right Speaker	Amplifier/Receiver	Left Speaker

jacks, which will allow the PRO-SW60P’s volume to change with the TV’s volume. Refer to your TV owner’s manual. Also, you can connect to the TV line out and then adjust the TV volume up or down. If the subwoofer volume changes with the TV volume, then the TV line out is variable.

Connecting to Speaker

+ –

+–

	HIGH LEVEL OUTPUT			SUB OUT/PRE OUT TERMINAL
HIGH+	LEVELR – OUTPUT– L		+	SUB OUT/PREL	OUT TERMINAL
+ R	–	– L	+	L
				R
				R

+ –

			+	–
HIGH LEVEL INPUT
R	L
	LOW LEVEL
+	INPUT	VOLUME	FREQUENCY
+		CONTROL	HZ
		L

HIGH LEVEL INPUT		R				POWER
R	L	R				POWER
R	L
		LOW LEVEL	MIN	MAX	50	200
+		INPUT	VOLUME		FREQUENCY
+		L	CONTROL			HZ
		L
		R				POWER
			MIN	MAX	50	200

Terminals

Connect the amplifier/receiver’s speaker output terminals to the PRO-SW60P’s HIGH LEVEL INPUT speaker terminals. Be sure to connect the terminals in phase, connecting positive (+) to positive and negative (–) to negative.

P/NO	WF –60R	U	LISTED 1Z45
			EQUIPMENT
		® L	AUDIO	AC120V
120V ~ 60Hz 60W E158878
SHOCK, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE
WARNING:	TO REDUCE THE RISK OF FIRE OR ELECTRIC			60Hz
	RISK DO NOT OPEN
	CAUTION

OF ELECTRIC SHOCK

1. Connect the PRO-SW60P’s LOW

LEVEL INPUT jacks to the amplifier/

receiver’s sub out or pre out jacks (or

TV’s audio line out jacks).

Right Speaker

+–

Amplifier/Receiver Output Terminal

Amplifier/ Receiver

HIGH LEVEL OUTPUT

+ R –		– L +

Left Speaker

+–

2. Connect your satellite speakers (if

any) to the amplifier’s or receiver’s

output terminals as they would

normally be connected.

Notes:

•On some receivers/amplifiers, the subwoofer out is a single jack. Use a single phono cable (not supplied, available at your local RadioShack store) to connect the subwoofer jack to the “L” input on the PRO-SW60P.

•When connecting to a TV, we recommend using variable line output

HIGH LEVEL INPUT
R	L
	LOW LEVEL
+	INPUT	VOLUME		FREQUENCY
+	L	CONTROL			HZ
	L
	R				POWER
		MIN	MAX	50	200

Connecting Speakers

You can connect your left and right speakers to your amplifier/receiver (see “Connecting to Subwoofer Out or Pre Out Terminals”), or to the PRO-SW60P’s HIGH LEVEL INPUT speaker terminals (see “Connecting to Speaker Terminals”).