Assembly

Assembly requires two persons. Place all parts of the exercise cycle in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed.

Assembly requires the included tools and your own adjustable wrench and Phillips screw-

driver .

Use the part drawings below to identify the small parts used in assembly. The number in parenthesis below each drawing refers to the key number of the part, from the PART LIST on page 10. The second number refers to the quantity needed for assembly. Note: Some small parts may have been pre-attached. If a part is not in the parts bag, check to see if it has been pre-attached.

M6 Nylon	M10 Black Nylon Locknut (50)–2		M8 Split		M10 Black Split	M10 Zinc
Locknut (53)–4 M10 Zinc Nylon Locknut (61)–2			Washer (56)–3		Washer (45)–2	Washer (62)–2
M6 x 16mm Button		M6 x 34mm Button			M8 x 37mm Button
Screw (57)–8		Screw (52)–4			Screw (55)–2
				M10 x 75mm Button Bolt (51)–2
M8 x 45mm Button Screw (54)–1
M10 x 56mm Carriage Bolt (49)–2				M10 x 85mm Carriage Bolt (48)–2

1.Identify the Front Stabilizer (2). Turn the Front Stabilizer so that the warning decal is in the position shown. While another person lifts the front of the Frame (1) slightly, attach the Front Stabilizer to the Frame with two M10 x 85mm Carriage Bolts (48) and two M10 Black Nylon Locknuts (50).

1	Decal
	48
	2
	1
	50