2.Attach the indicated end of the Seat Frame (3) to the Rear Stabilizer (9) with two M10 x 56mm Carriage Bolts (49), two M10 Zinc Washers (62), and two M10 Zinc Nylon Locknuts (61).
3.Slide the Seat Carriage (4) onto the other end of the Seat Frame (3). Make sure that the Seat Carriage is oriented as shown. Insert the end of the Seat Frame into the Frame (1), and attach it with two M10 x 75mm Button Bolts (51) and two M10 Black Split Washers (45).
Insert the Seat Knob (28) into the welded nut (not shown) on the right side of the Seat Carriage (4) and into one of the adjustment holes in the right side of the Seat Frame (3). Tighten the Seat Knob into the welded nut.
4.Slide a Handlebar (7) onto one side of the Seat Carriage (4). Attach the Handlebar with two M6 x 34mm Button Screws (52) and two M6 Nylon Locknuts
Attach the other Handlebar (7) to the Seat Carriage (4) in the same way.
5.Attach the Backrest Frame (5) to the Seat Carriage (4) with an M8 x 45mm Button Screw (54) and an M8 Split Washer (56) from the top, and two M8 x 37mm Button Screws (55) and two M8 Split Washers (56) from the bottom.
Next, attach the Backrest (10) to the Backrest Frame
(5)with four M6 x 16mm Button Screws (57).
2 |
| 49 |
|
| |
3 |
|
|
9 |
|
|
|
| 62 |
62 | 61 | |
| ||
3 |
|
|
1 |
| 4 |
|
| |
|
| 28 |
45 |
|
|
45 |
| 3 |
|
| |
51 |
|
|
4 |
|
|
|
| 7 |
4 |
|
|
53 |
|
|
7 | 52 |
|
5 |
|
|
10 |
|
|
|
| 5 |
54 |
|
|
56 |
| 57 |
4 |
|
|
|
| 56 |
|
| 55 |
5