Assembly

Assembly requires two persons. Place all parts of the exercise		cycle in a cleared area		and remove		the packing
materials. Do not dispose of the packing materials	until assembly	is completed.	Assembly		requires	the includ-
ed tools and your own adjustable wrench _,	Phillips screwdriver		_	_,	and

pliers _.

Use the drawings below to identify the small parts used for assembly. The number in parentheses below each drawing is the key number of the part, from the PART LIST on page 14. The number following the key number is the quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the parts bag, check to see if it has been preassembled.

			l\
M4 x 25mm Round	M8 Nylon	M8 Split	M8 Washer
Head Screw (41)-3	Locknut (10)-4	Washer (42)-3	(54)-4

M6 x 15mm Button	M8 x 20mm	M8 x 55mm Button
Screw (46)-4	Button Screw (34)-3	Screw (30)-4

MIO x 60mm Button

Screw (33)-2

1.Slide the Rear Stabilizer (6) into the Frame (1). Attach the Rear Stabilizer with four M8 x 55mm

Button Screws (30).

i i

2.Orient the Front Stabilizer (2) with the large holes

facing the Frame (1). Attach the Front Stabilizer to the Frame with two M10 x 60mm Button

Screws (33).

Large --. Holes