8.Whilea secondpersonholdstheConsole(16)near theUpright(13),connecttheconsolewiretothe ExtensionWire(52).Then,insertthewiresdown- wardintotheUpright.
16
AttachtheConsole(16)to theUpright(13)withfour M6x 15mmButtonScrews(46).Becarefulto avoidpinchingthewires.
52
Console
Wire
46
Be careful to
avoid pinching the wires.
9.IdentifytheLeftPedal(24),whichis markedwitha "Left"stickerUsingan. adjustablewrench,firmly tightentheLeftPedalcounterclockwise into the left
arm of the Crank (21). Tighten the Right Pedal (not shown) clockwise into the right arm of the Crank. Important: Tighten both Pedals as firmly as pos- sible. After using the exercise cycle for one week, retighten the Pedals. For best performance, keep the Pedals tightened.
Adjust a Pedal Strap (53) to the desired position,
and press the end of the Pedal Strap onto the tab on
the side of the Left Pedal (24). Adjust the other21 Pedal Strap (not shown) in the same way.
24
/
10.Make sure that all parts are properly tightened before you use the exercise cycle, Note: After assembly is completed, some extra parts may be left over. Place a mat beneath the exercise cycle to protect the floor.
7