PROBLEM

Will not start

Hard to start

Engine will not turn over

Engine clicks bat will not start

Loss of power

 

TROUBLESHOOTING

POINTS

 

 

 

 

 

 

 

 

 

 

 

 

 

CAUSE

 

 

 

 

 

 

 

 

 

 

 

 

CORRECTION

1.

Out of fuel.

 

 

 

 

 

 

1.

Fill fuel tank.

 

 

 

 

 

 

 

 

 

2.

Engine

not"CHOKED"

properly.

2.

See "TO START ENGINE"

in Operation section.

3.

Engine

flooded.

 

 

 

 

 

3.

Wait several

 

minutes before attempting to start.

4.

Bad spark

plug.

 

 

 

 

4.

Replace

 

spark

plug.

 

 

 

 

 

 

5.

Dirty

air

filter.

 

 

 

 

 

 

5.

Clean/replace

 

air

filter.

 

 

 

 

6.

Dirty

fuel filter.

 

 

 

 

 

6.

Replace

 

fuel

filter.

 

 

 

 

 

 

7.

Water

 

in fuel.

 

 

 

 

 

 

7.

Drain fuel tank and carburetor,

refill

tank with fresh

 

 

 

 

 

 

 

 

 

 

 

 

 

gasoline and replace fuel filter.

 

 

8.

Loose

 

or damaged

wiring.

 

8.

Check

all wiring.

 

 

 

 

 

 

 

9.

Carburetor

out

of adjustment.

9.

See Engine

Manual.

 

 

 

 

 

 

10.

Engine valves out of adjustment.

10.

Contact

an

authodzed

 

service

center/department.

11.

Extreme

cold

conditions.

 

11.

See "To start

engine"

in operation section.

1.

Dirty

air

filter.

 

 

 

 

 

 

1.

Clean/replace

 

air

filter.

 

 

 

 

2.

Bad spark

plug.

 

 

 

 

2.

Replace

 

spark

plug.

 

 

 

 

 

 

3.

Weak

 

or dead

battery.

 

 

3.

Recharge

or

replace

battery.

 

 

4.

Dirty

fuel filter.

 

 

 

 

 

4.

Replace

 

fuel

filter.

 

 

 

 

 

 

5.

Stale

or

dirty

fuel.

 

 

 

5.

Drain fuel tank and refill with fresh gasoline.

6.

Loose

 

or

damaged

wiring.

 

6.

Check

all wiring.

 

 

 

 

 

 

 

7.

Carburetor

out

of adjustment.

7.

See Engine

Manual.

 

 

 

 

 

 

8.

Engine valves out of adjustment.

8.

Contact

an

authodzed

 

service

center/department.

1.

Brake

 

pedal

not

depressed.

 

1.

Depress

 

brake

pedal.

 

 

 

 

 

 

 

2.

Disengage

attachment

 

clutch.

 

 

2.

Attachment

clutch

is engaged.

 

 

 

3.

Recharge

or

replace

battery.

 

 

3.

Weak

 

or dead

battery.

 

 

 

 

 

 

 

4.

Replace

 

fuse.

 

 

 

 

 

 

 

 

4.

Blown

 

fuse.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

5.

Clean

battery

terminals.

 

 

 

 

5.

Corroded

battery

terminals.

 

 

 

 

 

 

6.

Check

all wiring.

 

 

 

 

 

 

 

6.

Loose

 

or damaged

wiring.

 

 

 

 

 

 

 

 

 

 

7.

Checkheplace

 

ignition

 

switch.

 

 

7.

Faulty

 

ignition

switch.

 

 

 

 

 

 

 

 

 

8.

CheckJreplaca

 

solenoid

or

starter.

 

8.

Faulty

 

solenoid

or

starter.

 

 

 

 

 

9.

Contact

an

authodzed

 

service

center/department.

9.

Faulty

 

operator

 

presence

switch(es).

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

1.

Weak

 

or dead

battery.

 

 

1.

Recharge

or

replace

battery.

 

 

2.

Corroded

battery

terminals.

 

2.

Clean

battery

terminals.

 

 

 

3.

Loose

 

or

damaged

wiring.

 

3.

Check

all wiring.

 

 

 

 

 

 

 

4.

Faulty

 

solenoid

or

starter.

 

4.

CheckJreplaca

 

solenoid

or

starter.

 

1.

Cutting

 

too much grass/too

fast.

1.

Set in "Higher

 

Cut"

position/reduca

speed.

2.

Throttle

 

in "CHOKE"

position.

2.

Adjust

throttle

 

control.

 

 

 

 

 

3.

Buildup of grass,

leaves

and trash under deck.

3.

Clean

underside

of mower

housing.

 

4.

Dirty

air

filter.

 

 

 

 

 

 

4.

Clean/replace

 

air

filter.

 

 

 

 

5.

Low oil

level/dirty

oil.

 

 

5.

Check

oil levellchange

 

oil.

 

 

 

6.

Faulty

 

spark

plug.

 

 

 

6.

Clean and re-gap

or change spark

plug.

7.

Dirty

fuel filter.

 

 

 

 

 

7.

Replace

 

fuel

filter.

 

 

 

 

 

 

8.

Stale

or

dirty

fuel.

 

 

 

8.

Drain fuel tank and refill with fresh gasoline.

9.

Water

 

in fuel.

 

 

 

 

 

 

9.

Drain fuel tank and carburetor,

refill

tank with

 

 

 

 

 

 

 

 

 

 

 

 

 

fresh

gasoline

and

replace

fuel filter.

10.

Spark

 

plug wire

loose.

 

 

10.

Connect

 

and

tighten

spark

plug wire.

11.

Dirty

engine

air

screen/fins.

 

11.

Clean

engine

 

air

screen/fins.

 

 

12.

Dirty/clogged

muffler.

 

 

12.

Clean/replaca

 

muffler.

 

 

 

 

 

13.

Loose

 

or

damaged

wiring.

 

13.

Check

all wiring.

 

 

 

 

 

 

 

14.

Carburetor

out

of adjustment.

14.

See Engine

Manual.

 

 

 

 

 

 

15.

Engine valves out of adjustment.

15.

Contact

an

authodzed

 

service

center/department.

Excessive vibration 1. Worn, bent or loose blade.

2.Bent blade mandrel.

3.Loose/damaged part(s).

1.Replace blade. Tighten blade bolt.

2.Replace blade mandrel.

3.Tighten loose part(s). Replace damaged parts.

31

Page 31
Image 31
Husqvarna 968999245/ CZ3815, 968999246/CZ4217 manual Troubleshooting Points, Problem, Cause Correction