ASSEMBLY
CHECK THE TIRE PRESSURE
Correct tire pressure is important for best cutting performance and proper
Check the tire pressure and adjust
accordingly. Refer to the
"SPECIFICATIONS" section in this manual.
UTILITY BOX INSTALLATION
Place utility box onto factory preinstalled brackets.
Insert clevis pins through holes in utility box and brackets as shown.
Insert hairpins through holes in clevis pins.
Install tail gate into grooves in utility box, until seated.
NOTE: No riders and weight limited to less than 50 Ibs.
UTILITY BOX
CLEVIS PIN
\
HAIRPIN
COTTER
PREINSTALLED
FRONTBRACKET
CHECKLIST
PLEASE REVIEW THE FOLLOWING CHECKLIST
All assembly instructions have been completed
No remaining loose parts in crate or parts bag(s)
Seat is adjusted properly and securely fastened
All tires are properly inflated
Check wiring. See that all connections are still secure, and wires are properly clamped.
Before driving the mower, be sure the
WHILE LEARNING HOW TO USE
YOUR MOWER, PAY EXTRA
ATTENTION TO THE FOLLOWING
ITEMS:
Engine oil is at proper level
Fuel tank is filled with fresh, clean, regular unleaded gasoline. Check your engine manual for fuel requirements. Become familiar with all controls - their location and function. Operate them before you start the engine.
Become familiar with unit operation on a flat and level area with the mower deck
(blade PTO disengaged) shut off and engine at idle speed or partial throttle. Be sure the brake system is in a safe operating condition. If adjustment is needed see Service and Adjustment section.
REAR BRACKET
10
