Weslo WLTL41580 user manual Assembly

Page 5

ASSEMBLY

Assembly requires two people. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Refer to the drawings below to identify the small

parts used in assembly. Assembly requires your own phillips screwdriver , two adjustable

wrenches , and scissors .

1.Note that the Right Handrail and the Console Base (not shown) are connected to the treadmill by a Wire Harness. During assembly steps 1 through 5, be careful not to pull on or damage the Wire Harness.

With the help of a second person, carefully lay the treadmill on its side. Position one of the Base Legs (38) on the base of the Upright (31) as shown. Make sure that the Base Leg Pads (41) and the Front Wheel (39) are in the indicated positions. Attach the Base Leg with two 3/8Ó x 2Ó Bolts (43), two 3/8Ó Washers (44) and two 3/8Ó Nuts (34).

Carefully turn the treadmill onto its other side. Assemble the other Base Leg (38) as described.

With the help of a second person, carefully raise the treadmill to the upright position so the Base Legs

(38)are resting flat on the floor.

2.Without removing the tape from the Latch (18), hold the Latch against the left Upright as shown. Attach the Latch to the left Upright (31) with four Screws

(24).Make sure that the Screws are tight, but do not overtighten them; if the Screws are over- tightened, the Latch will not slide smoothly. After the Latch is attached, remove any visible tape.

Note: The inset drawing shows how the parts of the Latch (18) fit together.

3.Refer to HOW TO LOWER THE TREADMILL FOR USE on page 11. Follow the instructions in step 2 to lower the treadmill.

Cut the plastic ties that hold the cage nuts in each Handrail (30, 32).

Position the Left Handrail (30) on the left Upright

(31).Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer

(22)only a couple of turns into the upper end of the left Upright and the Left Handrail. Do not tighten the Bolt yet.

Thread a 1/4Ó x 1Ó Bolt (23) with a 1/4Ó Washer (22) only a couple of turns into the lower end of the Left Handrail (30) and the left Upright (31). Do not tight- en the Bolt yet.

1

 

43

 

 

 

39

 

 

 

44

 

31

 

 

41

 

34

 

38

 

 

 

2

 

 

 

 

31

 

 

18

 

 

 

 

 

Spacer

 

24

 

 

Springs

 

 

 

 

 

 

Latch

 

 

Bracket

 

3

 

 

 

 

23

 

 

 

 

22

 

 

 

 

30

 

 

31

 

 

 

22

23

 

 

 

5

Image 5
Contents Customer HOT Line QUESTIONS?Model No. WLTL41580 Serial No Important Precautions Table of ContentsPage Front Before YOU BeginBack Right SideAssembly Yet Performant Lubetm Walking Belt Operation and AdjustmentHOW to Plug in the Power Cord Step by Step Console Operation Diagram of the ConsoleBattery Installation When you are finished exercising, stop Insert the key fully into the power switchWalking belt is stopped and the ON/RESET Walking belt and remove the keyHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USE Top View Maintenance and TROUBLE-SHOOTINGProblem The power turns off during use 2ÓÐ3Ó Using the Hand Weights HOW to MEA Sure Your Heart RateConditioning Guidelines Exercise IntensitySuggested Stretches Workout GuidelinesQty Description Part LISTÑModel No. WLTL41580Exploded DRAWINGÑModel No. WLTL41580 Icon Health & FITNESS, INC., 1500 S W., LOGAN, UT Ordering Replacement PartsLimited Warranty