Weslo WLTL33205.0 Diagram of the Console, Battery Installation, Step by Step Console Operation

Page 9

DIAGRAM OF THE CONSOLE

 

Speed Control

Displays

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Clip

Key

CAUTION: Before operating the console, read the following precautions.

Do not stand on the walking belt when turning on the power.

Always wear the clip (see the drawing above) while using the treadmill. When the key is re- moved from the console, the walking belt will stop.

Adjust the speed in small increments.

The training zones marked above the speed control are general guidelines only. See page 15 for more information.

To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console. Use only a sealable water bottle.

BATTERY INSTALLATION

The console requires two "AA" batteries (not included). Alkaline batteries are recommended.

To install batteries, open the battery cover under the console as shown below. Press two batteries into the

battery com-

 

partment.

 

Make sure

 

that the neg-

Batteries

ative (–)

 

ends of the

 

batteries are

 

touching the

 

springs.

Battery

Close the

Cover

battery cover.

 

STEP BY STEP CONSOLE OPERATION

If there is a thin sheet of clear film on the face of the console, remove it.

Before operating the console, make sure that the power cord is properly plugged in. (See HOW TO PLUG IN THE POWER CORD on page 8.)

Next, step onto the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip onto the waistband of your clothing.

Important: In an emergency situation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully tak- ing a few steps backward; if the key is not pulled from the console, adjust the position of the clip.

Follow the steps on page 10 to operate the console.

9

Image 9
Contents Model No. WLTL33205.0 Serial No QUESTIONS?Call TOLL-FREE Mon.-Fri., 6 a.m.-6 p.m. MSTImportant Precautions Table of ContentsPage Before YOU Begin Right SideBack Side View Assembly Insert any extra Wire Harness 53 into the right Handrail Raise the Uprights 14, 15 to the vertical position Operation and Adjustment HOW to Plug in the Power CordPRE-LUBRICATED Walking Belt Diagram of the Console Battery InstallationStep by Step Console Operation Reset the speed control Insert the key fully into the power switchStart the walking belt CALS/FAT CalsHOW to Change the Incline of the Treadmill HOW to Fold the Treadmill for Storage HOW to Fold and Move the TreadmillHOW to Move the Treadmill HOW to Lower the Treadmill for USETroubleshooting Problem The power turns off during useTop View Problem The walking belt slows when walked on Conditioning Guidelines HOW to Measure Your Heart RateExercise Intensity Workout GuidelinesPart Identification Chart Key Qty Description R1005BExploded DRAWING-Model No. WLTL33205.0 Ordering Replacement Parts Limited WarrantyIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT