Weslo WLTL24308.0 user manual See the inset drawing. Locate the wire tie

4. With the help of a second person, raise the	4	Wire Tie
Handrails (80, 81) so the Base (87) is flat on the
floor as shown. Next, position the front of the
treadmill Frame (59) between the Handrails.
See the inset drawing. Locate the wire tie in-
side of the lower end of the Right Handrail (81).
Secure the wire tie to the Wire Harness (83).
Then, pull the upper end of the wire tie until the
end of the Wire Harness is extending from the	80			81
hole in the upper end of the Right Handrail.
Attach a Wheel (85) to the Base (87) with an M10
x 80mm Bolt (5) and an M10 Jam Nut (14).				14	85
Attach the other Wheel (not shown) in the		59	83
same way.					5
				87
			83	Wire		81
				Tie

5.Have a second person lift and hold the front end of the Frame (59). Hold a Frame Spacer (84) be- tween the Right Handrail (81) and the Frame.

Attach the Right Handrail to the Frame with an M10 x 110mm Bolt (3), an M10 Washer (12), and an M10 Star Washer (10). Do not tighten the

Bolt yet.

Repeat this step on the left side of the tread- mill.

5
81	84
10	12	3
59

8