Diagram of the Console, Battery Installation

Battery Cover

Batteries

Battery Cover

Tab

DIAGRAM OF THE CONSOLE

Displays

Speed Control

Note: If there is a sheet of clear plastic on the face of the console,removeitbefore operatingthe console.

CAUTION: Before operating the console, read the following precautions.

•Do not stand on the walking belt when turning on the power.

•Always wear the clip (see the drawing below) while using the treadmill. When the key is

removed from the console, the walking belt will stop.

•Adjust the speed in small increments.

•To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console. Put only sealable water bottles in the water bottle holders.

BATTERY INSTALLATION

The console requires two “AA” batteries (not included).

Alkaline batter-

ies are recom- mended. To

install batteries, open the bat- tery cover beneath the

console as shown. Press

two batteries into the con-

sole. Make sure that the negative (–) ends of the batteries are touching the springs. Close the battery cover, push up on the tab, and then push the tab for- ward as shown in the inset drawing. Make sure that the tab locks into place.

STEP-BY-STEP CONSOLE OPERATION

Before operating the console, make sure that the power cord is properly plugged in (see page 10).

	Step onto the
	foot rails of the
	treadmill. Find	Key
	the clip attached	Key
	the clip attached
	to the key, and
	slide the clip
	onto the waist-
	band of your
	clothes. Next,	Clip
	insert the key

fully into the con-

sole. Test the clip by carefully taking a few steps backward until the key is pulled from the console. If the key is not pulled from the console, adjust the position of the clip as needed.