4.Open part bag C. Set the Console Base (87) on the Handrails (4). Thread four 3/4” Screws (5) into the Handrails and the Console Base. After you have started all four Screws, tighten the Screws until they are snug; do not overtighten the Screws.
Insert the Wire Harness (53) through the two indicated plastic ties on the Console Base (87) and then through the hole in the bottom of the Console Base.
5.Insert the Battery Cover (12) up through the bottom of the Console Base (87), with the hinges in the position shown. The Battery Cover should pivot down, away from the Console Base.
Remove the tape from the connectors.
6.Hold the Console (11) near the Console Base (87).
Touch the right Handrail (4) to discharge any static.
Locate the two wires in the Wire Harness (53) that have
Connect the other two wires in the Wire Harness (53) to the back of the Console (87) in the locations shown by the arrows in drawing 6. The connectors should slide easily into the sockets and snap into place (see drawings 6b and 6c). If the connectors do not slide easi- ly and snap into place, turn the connectors and then insert them. IF THE CONNECTORS ARE NOT INSERT-
ED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
4 |
| 87 |
|
|
|
|
| 4 | |
| 4 |
|
|
|
| Ties | 53 |
| 5 |
|
|
| ||
|
|
|
| |
| 5 |
|
|
|
5 |
|
|
|
|
|
|
| 87 | Connectors |
|
|
|
| |
|
|
| Hinges | |
|
| 12 |
|
|
6 |
|
|
|
|
|
|
| 11 |
|
87 | 53 |
| 6a | Tabs |
|
|
| ||
|
| 53 | 6b |
|
|
|
|
| |
| Ties |
|
|
|
| 4 |
| 6c |
|
|
|
|
| |
8