Weslo WLTL19709.0 user manual Troubleshooting, Compatible with GFCI-equipped outlets

Page 14
2–3 in.
Idler Roller Bolts

TROUBLESHOOTING

Most treadmill problems can be solved by following the steps below. Find the symptom that applies, and follow the steps listed. If further assistance is needed, please see the front cover of this manual. PROBLEM: The power does not turn on

SOLUTION: a. Make sure that the power cord is plugged into a surge suppressor, and that the surge suppressor

is plugged into a properly grounded outlet (see page 8). Use only a single-outlet surge suppres-

sor that meets all of the specifications described on page 8. IMPORTANT: The treadmill is not

compatible with GFCI-equipped outlets.

 

 

b. After the power cord has been plugged in, make sure that the key is inserted into the console.

c. Check the on/off switch located on the treadmill

c

 

frame near the power cord. If the switch protrudes

 

as shown, the switch has tripped. To reset the

Tripped

On

switch, wait for five minutes and then press the

switch back in.

 

 

PROBLEM: The power turns off during use

SOLUTION: a. Check the on/off switch (see the drawing above). If the switch has tripped, wait for five minutes and then press the switch back in.

b.Make sure that the power cord is plugged in. If the power cord is plugged in, unplug it, wait for five minutes, and then plug it back in.

c.Remove the key from the console. Reinsert the key into the console.

d.If the treadmill still will not run, please see the front cover of this manual.

PROBLEM: The walking belt slows when walked on

SOLUTION: a. Use only a single-outlet surge suppressor that meets all of the specifications described on page 8.

b. If the walking belt is overtightened, treadmill perfor- b mance may decrease and the walking belt may be- come damaged. Remove the key and UNPLUG

THE POWER CORD. Using the hex key, turn both idler roller bolts counterclockwise, 1/2 of a turn. When the walking belt is properly tightened, you should be able to lift each edge of the walking belt 2 to 3 in. (5 to 7 cm) off the walking platform. Be careful to keep the walking belt centered. Then, plug in the power cord, insert the key, and run the treadmill for a few minutes. Repeat until the walk- ing belt is properly tightened.

c. If the walking belt still slows when walked on, see the front cover of this manual.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Model No. WLTL19709.0 Serial No Contact the Store Where YOU Purchased this ProductQUESTIONS? Table of Contents Important Precautions Save These InstructionsBefore YOU Begin Assembly Make sure that the power cord is unpluggedMake sure that the Console Knobs 3 are Operation and Adjustment HOW to Plug in the Power CordKey Clip Console DiagramFeatures of the Console Select the manual mode HOW to Turn on the PowerHOW to USE the Manual Mode Insert the key into the consoleFollow your progress with the display Measure your heart rate if desired. If there areHOW to USE a Preset Workout Select a preset workoutHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USEProblem The walking belt slows when walked on TroubleshootingProblem The power turns off during use Compatible with GFCI-equipped outletsProblem Solution Lubricating the Walking BeltWorkout Guidelines Exercise GuidelinesExercise Intensity Exercise FrequencyPart LIST-Model No. WLTL19709.0 Key No. Qty DescriptionExploded Drawing A-Model No. WLTL19709.0 R0210A Exploded Drawing B-Model No. WLTL19709.0 Ordering Replacement Parts

WLTL19709.0 specifications

The Weslo WLTL19709.0 is a formidable treadmill that has gained popularity among fitness enthusiasts and casual users alike. Designed with a focus on usability and efficiency, this treadmill boasts a range of features and technologies that cater to various workout preferences and fitness levels.

One of the standout characteristics of the Weslo WLTL19709.0 is its 2.25 HP Impulse Motor, which provides a smooth and consistent running experience. This motor ensures that users can enjoy effective cardio workouts, whether they are brisk walking, jogging, or running. The treadmill has a top speed of 10 mph, allowing users to adjust their intensity as they progress in their fitness journey.

The Weslo WLTL19709.0 features a spacious running surface of 16 inches by 50 inches, accommodating users of different heights and strides. This generously sized deck provides ample space for comfortable workouts while reducing the risk of injury, making it suitable for both beginners and more experienced runners.

In terms of technology, the treadmill is equipped with an LCD display that provides real-time feedback on essential workout metrics, including speed, distance, time, and calories burned. This information helps users monitor their progress and stay motivated throughout their sessions. Additionally, the treadmill includes six workout programs designed by certified personal trainers, ensuring variety and engagement in each workout session.

The Weslo WLTL19709.0 is designed for convenience and ease of use. It features a folding design, allowing users to save space when the treadmill is not in use. The hydraulic shock assist system makes the folding and unfolding process smooth and hassle-free. The treadmill's frame is sturdy yet lightweight, enabling easy relocation within your home gym or living space.

Another great feature is the comfort cell cushioning system, which provides added support to the user’s joints during workouts. This cushioning helps absorb impact and reduce strain, making it ideal for those who may need extra protection for their knees and ankles.

Overall, the Weslo WLTL19709.0 combines practical features, advanced technologies, and user-friendly designs, ensuring a comprehensive fitness experience suitable for a wide range of users. Whether you’re preparing for a race or just looking to maintain a healthy lifestyle, this treadmill offers an excellent blend of performance and convenience.
Top Page Image Contents