Weslo WLTL19205.2 user manual Diagram of the Console, STEP-BY-STEP Console Operation

Page 10

DIAGRAM OF THE CONSOLE

Note: If there is a sheet of clear plastic

 

on the console, remove the plastic.

Key

Clip

CAUTION: Before operating the console, read the following precautions.

Do not stand on the walking belt when turn- ing on the power.

Always wear the clip (see the drawing above) while operating the treadmill.

Adjust the speed in small increments to avoid sudden jumps in speed.

To reduce the possibility of electric shock, keep the console dry. Avoid spilling liquids on the console and place only sealed water bottles in the water bottle holders.

STEP-BY-STEP CONSOLE OPERATION

Before operating the con-

 

 

 

 

 

 

 

 

sole, make sure that the

 

 

 

 

 

 

 

 

power cord is properly

 

 

 

 

plugged in (see page 9).

 

 

 

 

Next, locate the reset/off cir-

 

Reset

 

cuit breaker on the treadmill

 

 

 

 

 

 

 

 

 

 

 

 

frame near the power cord,

 

 

 

 

and make sure that the circuit breaker is in the reset position.

Next, stand on the foot rails of the treadmill. Find the clip attached to the key (see the drawing above), and slide the clip securely onto the waistband of your clothes. Then, insert the key fully into the console. After a moment, the display will light. Important: In an emergency situation, the key can be pulled from the console, causing the walking belt to slow to a stop. Test the clip by carefully taking a few steps backward; if the key is not pulled from the console, adjust the position of the clip.

Follow the steps below to operate the console.

1 Insert the key fully into the console.

A moment after the key is inserted, the display will light.

Press the Digital Speed increase button to start

2 the walking belt.

A moment after the button is pressed, the walking belt will begin to move at 1 mph. Hold the handrails and begin walking. As you exercise, change the speed of the walking belt as desired by pressing the Digital Speed buttons. Each time a button is pressed, the speed setting will change by 0.1 mph; if a button is held down, the speed setting will change in increments of 0.5 mph.

10

Image 10
Contents Call TOLL-FREE QUESTIONS?Model No. WLTL19205.2 Serial No Mon.-Fri., 6 a.m.-6 p.m. MSTTable of Contents Important Precautions Unplug Treadmill before Assembly /Disassembly Before YOU Begin Left Side Right SideAssembly Touch the Right Handrail to discharge any static Plastic HOW to Plug in the Power Cord Operation and AdjustmentPRE-LUBRICATED Walking Belt STEP-BY-STEP Console Operation Diagram of the ConsoleInsert the key fully into the console HOW to Change the Incline of the Treadmill Monitor your progress with the displayHOW to Move the Treadmill HOW to Fold and Move the TreadmillHOW to Fold the Treadmill for Storage HOW to Lower the Treadmill for USEProblem The power turns off during use Maintenance and TroubleshootingTop View Problem The walking belt slows when walked on Exercise Intensity HOW to Measure Your Heart RateConditioning Guidelines Workout GuidelinesR0606A Qty DescriptionPart Identification Chart Exploded DRAWING-Model No. WLTL19205.2 Limited Warranty Ordering Replacement PartsIcon Health & FITNESS, INC., 1500 S W., LOGAN, UT