MAINTENANCE AND TROUBLESHOOTING
Inspect and tighten all parts of the exercise cycle reg- ularly. Replace any worn parts immediately.
To clean the exercise cycle, use a damp cloth and a small amount of mild detergent. Important: To avoid damage to the console, keep liquids away from the console and keep the console out of direct sunlight.
BATTERY REPLACEMENT
If the console display becomes dim, the batteries should be replaced; most console problems are the result of low batteries. To replace the batteries, see assembly step 9 on page 7.
HOW TO ADJUST THE REED SWITCH
HOW TO ADJUST THE BELT
If you can feel the pedals slip while you are pedaling, even when the resistance is at the highest level, the belt may need to be adjusted.
To adjust the belt, remove the left and right side shield covers. Next, loosen, but do not remove, the
M8 x 20mm Bolt (23). Loosen the two M8 Nylon Locknuts (10), one on each side of the Flywheel (37). Then, tighten the M6 Nylon Locknuts (63), one on each side of the Flywheel, until the belt is properly tightened. Finally, tighten the M8 Nylon Locknuts (10) and the M8 x 20mm Bolt (23). Then, reattach the side shield covers.
I
If the console does not display correct feedback, the reed switch should be adjusted. To adjust the reed switch, first remove the left side shield cover.
Next, turn the resistance knob to the lowest setting. With the left side shield cover removed, locate the Reed Switch (43). Turn the Crank (21) until the Magnet (38) is aligned with the Reed Switch. Loosen, but do not remove, the M4 x 15mm
12