Weslo WATL26806.0 user manual Make sure that the power cord is unplugged, Upright Bolts yet

1. Make sure that the power cord is unplugged.	1
Attach a Wheel (95) to each side of the Base				94
(37) with a Wheel Bolt (4), two Wheel Spacers			95
(94), and a Nut (12) as shown. Do not over-			39		4
tighten the Wheel Bolts; the Wheels should			94
turn freely.
Identify the Right Upright (39), which has a			12
		95	94
square hole in the location shown.
		94
			12
Orient the Right Upright (39) and the Base (37)
as shown. Attach the Right Upright to the Base		4
with two Upright Bolts (4) and two Upright Star					6
			37
Washers (6); do not tighten the Upright Bolts
yet.					4
			Square
			Hole
2. Orient the Left Upright (38) as shown, and attach	2
it to the Base (37) with two Upright Bolts (4) and
		Latch
two Upright Star Washers (6); do not tighten
		Holes
the Upright Bolts yet.
			37
			38
					6
				6	4
3. With the help of a second person, raise the	3
Uprights (38, 39) so the Base (37) is flat on the		38
			39
floor as shown. Next, position the front of the
treadmill Frame (36) between the Uprights.
See the inset drawing. Locate the wire inside the			39
lower end of the Right Upright (39). Tie the wire		Wire	69		69
securely to the end of the Upright Wire (69).
Next, insert the wire and the end of the Upright					Wire
Wire into the hole in the Right Upright.
	36		37
	7