ASSEMBLY
The help of a second person is recommended. Set the treadmill in a cleared area and remove all packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires a phillips
screwdriver 
and an adjustable wrench 
(not included).
1.Slide the Handrail (6) onto the four welded bolts in the Base (19) as shown.
See the inset drawing. Attach each side of the Handrail
(6) to the Base (19) with two M8 Nylon Nuts (16).
2.Lift the front of the Frame (32, 35) and align the holes near the front of the Frame with one of the three sets of holes in the Handrail (6). Insert the two Long Pins (5) into the Handrail and the Frame. Make sure that the
Long Pins are fully inserted at the same level.
See the inset drawing. Insert a Cotter Pin (8) into the hole near the end of each Long Pin (5). Make sure that the Cotter Pins are fully inserted.
3.Attach the Console Plate (2) to the Handrail (6) with two M4 x 16mm Screws (3) as shown. Feed the Reed Switch Wire (7) up through the indicated hole in the Console Plate.
Hold the Console (1) near the Console Plate (2). Plug the Reed Switch Wire (7) into the back of the Console. Feed the excess Reed Switch Wire down through the hole in the Console Plate. Attach the Console to the Console Plate with four M4 x 16mm Screws (3). Be careful not to pinch the Reed Switch Wire.
1 |
|
|
|
| 6 |
| 19 |
|
|
| 6 |
|
| 16 |
|
| 19 |
|
| Bolts |
2 |
|
|
5 |
| 6 |
|
| |
32 |
| 5 |
|
| |
8 |
|
|
|
| 35 |
5 |
|
|
3 |
| 1 |
6 | 2 | 3 |
| ||
|
| |
|
| 7 |
| 3 | 3 |
|
| 3 |
4