6.With the help of a second person, lift and hold the Frame (79) between the Right Handrail (59) and the Left Handrail (not shown). Finger tighten a 4” Bolt (70) with a 3/8” Washer (66) and a 3/8” Star Washer (29) through the Right Handrail and the Frame Spacer (27) into the Frame. Do not tighten the Bolt yet. Repeat this step on the left side of the treadmill.
7.Orient the Crossbar (91) with the large hole at the right of the smaller hole as shown. Set the Crossbar against the Handrails (53, 59) with the brackets on the Crossbar aligned with the two small holes in each Handrail. Attach the Crossbar with two Crossbar Star Washers (93) and two Crossbar Screws (92). Do not tighten the
Crossbar Screws yet.
With the help of as second person, hold the console assembly near the Crossbar (91). Connect the pulse wire from the Crossbar to the pulse wire from the con- sole assembly. The connectors should slide easily into each other and snap into place. If they do not slide easi- ly and snap into place, turn a connector and then insert it.
Insert the ground wire through the two plastic ties shown in step 8. Attach the end of the ground wire to the small hole in the side of the Right Handrail (59) with a Silver Ground Screw (69).
8.Place the Console Base (52) on the Crossbar (91), Right Handrail (59) and the Left Handrail (not shown). Be care- ful not to pinch any wires. Attach the Console Base with four 3/4” Screws (2) (only two Screws are shown). Do not overtighten the Screws.
Insert the Wire Harness (60) through the two indicated plastic ties on the Console Base (52). Next, touch the Right Handrail (59) to discharge any static. See the inset drawing. Insert the connector on the end of the Wire Harness into the red socket beneath the console. The connector should slide easily into the socket and snap into place. If the connector does not slide easily and snap into place, turn the connector and then insert it.
Make sure that the connector and wire appear as shown in the inset drawing. IF THE CONNECTORS ARE NOT
INSERTED PROPERLY, THE CONSOLE MAY BE DAMAGED WHEN THE POWER IS TURNED ON.
8
6 |
|
|
|
| 59 |
|
|
|
| 29 |
|
|
|
| 66 |
| 27 |
| 70 |
|
|
| |
79 |
|
|
|
7 |
|
|
|
|
|
| Console |
|
|
| Assembly |
53 |
|
| Ground |
|
|
| |
|
| 69 | Wire |
93 | 91 |
|
|
92 | Pulse |
|
|
| Wires |
| 93 |
|
| 59 | |
|
| 92 | |
|
|
| |
8 | 52 |
|
|
| 60 |
|
|
| Ties | 91 |
|
2 |
|
| |
|
|
| |
59 |
| 60 |
|
|
|
| |
|
|
| Socket |