Maintenance and Troubleshooting, When walked

MAINTENANCE AND TROUBLESHOOTING

Most problems can be solved by following the simple steps below. If further assistance is needed, call

our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday, 6 a.m. until 6 p.m. Mountain Time (excluding holidays).

1.SYMPTOM: THE CONSOLE DOES NOT FUNCTION PROPERLY

a.Replace the batteries in the console (see assem- bly step 6 on page 5).

b.Make sure that the reed switch is properly adjust- ed (see assembly step 4 on page 4).

c.Make sure that the handrail wire is plugged fully into the wire on the console (see assembly step 7 on page 5).

d.The console, like most electronics, is susceptible

to static electricity build-up caused by certain

types of clothing or by the operation of the tread- mill. If the display is blank or gives incorrect read-

ings, apply an anti-static spray to the handrail. Anti-static spray is available where laundry sup- plies are sold.

2.SYMPTOM: THE WALKING BELT DOES NOT MOVE SMOOTHLY

	a. If the walk-
	ing belt is	Walking Belt
	overtight-	Walking Belt
	overtight-
	ened, per-
	formance
	may be
	reduced and
	the walking
	belt may be	2"–3"
	permanently	2"–3"
	permanently
	damaged.	Bolts
	Using the	Bolts
	Using the
	allen

wrench, turn both rear roller adjustment bolts
counterclockwise 1/4 of a turn. When the tension
of the walking belt is correct, you should be able
to lift each side of the walking belt 2 to 3 inches.
Walk on the treadmill for a few minutes. R	epeat
until the walking belt is properly tightened. Be
careful to keep the walking belt centered.

3.SYMPTOM: THE WALKING BELT SLIPS OR IS OFF-CENTER

a.If the walking belt slips

when walked

on , use the

allen wrench to turn both adjustment

bolts clockwise,

1/4 of a turn. When the walking belt is correctly tightened, you should be able to lift each side of the walking belt 2 to 3 inches. Walk on the tread- mill for a few minutes. Repeat until the walking belt is properly tightened. Be careful to keep the walking belt centered.

b.If the walking belt has shift- ed to the left

side , use the

allen wrench to turn the left adjustment bolt

clockwise, and

the right adjustment bolt counterclockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few min- utes. Repeat until the walking belt is centered.

c.If the walking

belt has shift- ed to the right side , use the

allen wrench to turn the left adjustment bolt

counterclock-

wise, and the right adjustment bolt clockwise, 1/4 of a turn each. Be careful not to overtighten the walking belt. Walk on the treadmill for a few min- utes. Repeat until the walking belt is centered.