Weslo WETL14906.0 user manual Assembly, Spanners Wire cutters

ASSEMBLY

Assembly requires two persons. Set the treadmill in a cleared area and remove all packing materials; do not dispose of the packing materials until assembly is completed. Note: The underside of the treadmill walking belt is coated with high-performance lubricant. During shipping, a small amount of lubricant may be transferred to the top of the walking belt or the shipping carton. This does not affect treadmill performance. If there is lubricant on top of the walking belt, simply wipe off the lubricant with a soft cloth and a mild, non-abrasive cleaner.

In addition to the included hex key , assembly requires a phillips screwdriver			, two
spanners	, and wire cutters	.

Note: To identify small parts used during assembly, see the PART IDENTIFICATION CHART in the center of this manual. Some parts may be preassembled.

1.Have a second person hold the Base (52) in the position shown.

Identify the Left Upright (53) (the Right Upright [54] has a large hole near the lower end).

Hold the Left Upright (53) so the bend is in the posi- tion shown. Attach the Left Upright to the Base (52) with two Upright Bolts (2). Do not tighten the Upright Bolts yet.

Attach the Right Upright (54) to the Base (52) in the same way.

2.Slide the two Wheel Housings (62) onto the Base (52), with the heads of the Wheel Bolts (35) on the outside as shown. Attach each Wheel Housing with two Wheel Housing Bolts (6), two Wheel Housing Washers (11), and two Wheel Housing Nuts (15).

1
	52
	54
		2
	Large
	Hole		2
	53
		Bend
2	35
	62	15
	6	11	35
	52	62	15
			11
		6

6