3.With the help of a second person, raise the Uprights (53, 54) so the Base (52) is flat on the floor as shown. Next, position the front of the treadmill Frame (51) between the Uprights.
See the inset drawing. Locate the wire inside the lower end of the Right Upright (54). Secure the wire to the Wire Harness (98). Next, locate the opposite end of the wire, which is extending from the upper end of the Right Upright. Pull the wire until the end of the Wire Harness is extending from the indicated hole in the Right Upright.
Have a second person lift and hold the front end of the Frame (51). Hold a Frame Spacer (111) between the Right Upright (54) and the Frame. Attach the Right Upright and the Frame Spacer to the Frame with a Frame Pivot Bolt (1), a Frame Washer (14), and a Frame Star Washer (9).
Repeat this step on the left side of the treadmill. Note: There is not a wire on the left side of the treadmill.
Remove the wire from the Wire Harness (98).
4.Turn the Console Assembly (91)
Identify the Right Handrail (55), which has a large hole in one side.
Attach the Right Handrail (55) to the Console Assembly (91) with two Console Screws (4), a Crossbar Screw (5), and a Crossbar Star Washer (12).
3 | Hole |
|
|
| |
53 |
|
|
| 54 |
|
|
| 111 |
| 98 |
|
|
| 14 |
| 52 | 9 |
| 1 | |
51 | Wire |
|
| 98 | 54 |
|
| |
4 |
|
|
| 5 |
|
| 12 |
|
| 4 |
|
| Large Hole | 55 |
|
| |
| 91 |
|
7