Whenkey. you are finished exercising, remove

Mode Indicator

To stop the walking belt, press the Stop button. The elapsed time will begin to flash in the Time display.

Note: During the first few minutes that the tread- mill is used, inspect the alignment of the walking belt, and align it if necessary (see page 17).

3 Follow your progress with the four displays.

Time display—This dis- play shows the elapsed time. When the Stop but- ton is pressed, the elapsed time will flash.

Distance display—This display shows the dis- tance that you have walked or run.

Speed display—This display shows the speed of the walking belt.

Fat Calories/Calories display—This display shows the approximate

numbers of fat calories and calories you have burned (see FAT BURN-

ING on page 18). The display will change from

one number to the other every few seconds, as shown by the mode indicators.

Note: The console can

display speed and dis- tance in either miles or kilometres. To change

the unit of measurement, hold down the Stop but-

ton, insert the key into the console, and continue to hold the Stop button for a moment. An “E” for English miles or an “M” for metric kilometres will appear in the Fat Calories/Calories display. Press the Speed ▲ button to change the unit of mea- surement. When the desired unit of measurement is selected, remove the key and then reinsert it.

To reset the displays, press the Stop button, re- move the key, and then reinsert the key.

4 Whenkey. you are finished exercising, remove the

Step onto the foot rails, press the Stop button, and remove the key from the console. Keep the key in a secure place. Move the on/off switch near the power cord to the off position and unplug the power cord.

HOW TO CHANGE THE INCLINE OF THE TREADMILL

To vary the intensity of your exercise, the incline of the treadmill can be changed. There are four incline levels.

Before changing the incline, remove the key and unplug the power cord.

Next, fold the treadmill to the storage position (see HOW TO FOLD THE TREADMILL FOR STORAGE on page 14).

To change the incline, remove the incline pin from the right incline leg as shown below. Adjust the incline leg to the desired height and fully reinsert the incline pin.

Make sure that the incline pin is in the “locked” position shown in the inset drawing. Adjust the left incline leg in the same way. Make sure that both incline pins are inserted from the direction shown.

Incline

Right

Incline

Leg

Incline

CAUTION: Before using the treadmill, make sure that both incline pins are fully inserted at the same height. Do not use the treadmill with the incline pins removed.

After you have adjusted the incline legs, lower the treadmill (see HOW TO LOWER THE TREADMILL FOR USE on page 15).