5.See the inset drawings and identify the two Crossbar Screws (86); be careful not to confuse the Crossbar
Screws with the 3/4” Screws (77). The Crossbar Screws are slightly larger than the 3/4” Screws.
Hold the Crossbar (65) on the small brackets on the Handrails (4, 5). Attach the Crossbar to the small brack- ets with the two Crossbar Screws (86). Do not tighten the Crossbar Screws yet.
Attach the end of the ground wire on the Wire Harness
(53)to the small hole in the left side of the Right Handrail
(5)with the Silver Ground Screw (89).
6.Place the Console Base (45) on the Right Handrail (5) and the Left Handrail (not shown). Attach the Console Base with four 3/4” Screws (77) (only two Screws are shown). Do not tighten the Screws yet.
Insert the Wire Harness (53) through the two indicated plastic ties on the Console Base (45). Next, insert the Wire Harness up through the opening beside the Wire Cover (50). Make sure that the Wire Cover is securely at- tached to the Console Base.
See drawing 6a. Look at the top of the Console Base (45). Insert the Wire Harness (53) through the plastic tie on top of the Console Base.
Tighten the two Crossbar Screws (86) (only one is shown).
7.Press the Book Rack (49) onto the Console Base (45) in the location shown.
5 | Small Bracket |
|
65 53
86
489
Small Bracket
|
| 5 | 86 |
| 86 |
| 77 |
6 | 45 |
|
|
|
|
| |
|
| 53 |
|
|
|
| 50 |
| Ties |
|
|
| 86 |
|
|
77 | 5 | 6a |
|
|
| ||
|
|
| |
|
| 53 |
|
|
|
| Tie |
|
|
| 45 |
7 |
|
|
|
|
| 49 |
|
| 45 |
|
|
8